Humminbird HDR 650 manual Installation Overview

Page 6

Installation Overview

Before you start installation, we encourage you to read these instructions carefully in order to get the full benefitfrom your HDR 650 DigitalDepth Sounder.

In addition to the hardware included in the installation kit, you will also need the following supplies:

•powered hand drill and various drill bits, includinga 2 1/8" hole saw if your boat does not have an existing gauge hole

•Phillips-head and flat-head screwdrivers

•ruler or measuring tape

•pen or pencil

•12 Volt power source (your boat's battery)

•marine-grade silicone sealant (for sealing drilled holes)

•two-part, slow-cure epoxy (for inside-the-hull transducerinstallation only)

NOTE: If you are wiring directly to the boat's battery, you will also need a 1 Amp fuse and a fuse holder.

Installation

2

Image 6

Contents HDR 650 Installation Operations Manual Thank You Table of Contents Maintenance How Sonar Works Installation Overview Installing the HDR Locating the HDR 650 Mounting Position Cutting the Mounting HoleCustomizing and Assembling the HDR HDR Face Plate Trim Ring TabsInstalling the HDR Collar Gasket DashboardViewHDR 650 Control Head Installing the Buzzer Connecting to the Power SupplyBuzzer Installing the Transducer Inline Fuse HolderTransducer Installation Overview Rivets Strakes TransomHull Transom Transducer InstallationLocating the Transducer Mounting Position StepRibLevel Deadrise AnglePreparing the Mounting Location Assembling the Transducer and Initial Mounting 4th hole Mark InitialDrill Holes Transom Angle in degrees MeasuredWeight Distance Bead Alignment Number Transom Angle Measured DistanceKnuckle Beads Ratchet RibBead Ratchet Snap the pivot arm down into place One click too high Trailingedge One click too low Leading edgeRouting the Cable Transom Mount Transducer Installation Storing Excess Cable Gathered at one location as shown Connecting the CableTest and Finish the Installation See the illustration Storing Excess CableLevel Seam aligned with boat hull Bead Rib RatchetTransom Mount Transducer Installation Locking Down the Transducer Optional Inside the Hull Transducer Installation Trial Installation Positioning the Transducer and Preferred Mounting AreaRouting the Cable Permanently Mounting the Transducer Make sure the position of the transducer is markedTrolling Motor Transducer Installation Trolling Motor Transducer OptionsHDR 650 Control Head Units Shallow Alarm Icon IndicatesOperating the HDR DepthPower On/Off Key Functions OverviewUnits Set UnitsShallow Alarm Set Shallow Alarm IconDeep Alarm Set Deep Alarm IconNegativeOffset NumberIcon PostiveOffset NumberIconMaintenance HDR 650 MaintenanceTransducer Maintenance Troubleshooting HDR 650 Doesnt Power UpScreen Fades, Images are not Sharp No Bottom Reading on the DisplayNo Continuous Depth Display in Very Shallow Water Bottom Reading Disappears During a Hard TurnYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Specifications Contact Humminbird