1. Locating the HDR 650 Mounting Position
You must select an appropriate mounting location for the HDR 650. Consider different positions on the console or deck of the boat, and note the following:
•The cables for the transducer and power must reach the mountinglocation. Extension cables are available.
•The mountingsurface should be visible to the boat operator and adequately supported to protect the HDR 650 from excessive wave shock and vibration.
•Allow at least 2" clearance at the back, sides, and top of the unit for connection, air flow, and ease of installation and removal.
Choosing Mounting Hole Location
2. Cutting the Mounting Hole
Once you have selected your mounting location, perform the followingsteps:
1.Mark the desired mounting location, then drill a pilot hole.
2.Drill a 2 1/8" diameter hole using a hole saw and hand drill. This is a standard hole saw readilyavailablefor rentalor purchase. If you prefer,any marine service shop can perform this task.
Installation | 4 |