Humminbird HDR 650 manual Snap the pivot arm down into place

Page 20

Inserting the Pivot Arm Assembly	Prying the Assembly Away
Into the Mounting Bracket	from the Mounting Bracket

Mounting the Assembly

to the Transom

4.Align the mounting bracket transdu cer assembly with the drilled holes in the transom. With a 5/16" socket driver, mount the assembly to the transom using the two #10 - 1" long screws provided (see the illustration Mounting the Assembly to the Transom).

NOTE: Make sure that the mounting screws are snug, but do not fully tighten the mounting screws at this time to allow the transducer assembly to slide for adjustment purposes.

5.Snap the pivot arm down into place.

Transom Mount Transducer Installation

16

Image 20

Contents HDR 650 Installation Operations Manual Thank You Table of Contents Maintenance How Sonar Works Installation Overview Installing the HDR Locating the HDR 650 Mounting Position Cutting the Mounting HoleCustomizing and Assembling the HDR HDR Face Plate Trim Ring TabsHDR 650 Control Head Installing the HDRCollar Gasket DashboardView Buzzer Installing the BuzzerConnecting to the Power Supply Installing the Transducer Inline Fuse HolderTransducer Installation Overview Transom Transducer Installation Locating the Transducer Mounting PositionRivets Strakes TransomHull StepRibLevel Deadrise AnglePreparing the Mounting Location Drill Holes Assembling the Transducer and Initial Mounting4th hole Mark Initial Transom Angle in degrees MeasuredWeight Distance Bead Alignment Number Transom Angle Measured DistanceBead Ratchet Knuckle Beads RatchetRib Snap the pivot arm down into place One click too high Trailingedge One click too low Leading edgeRouting the Cable Transom Mount Transducer Installation Connecting the Cable Test and Finish the InstallationStoring Excess Cable Gathered at one location as shown See the illustration Storing Excess CableLevel Seam aligned with boat hull Bead Rib RatchetTransom Mount Transducer Installation Locking Down the Transducer Optional Inside the Hull Transducer Installation Trial Installation Positioning the Transducer and Preferred Mounting AreaRouting the Cable Permanently Mounting the Transducer Make sure the position of the transducer is markedTrolling Motor Transducer Installation Trolling Motor Transducer OptionsUnits Shallow Alarm Icon Indicates Operating the HDRHDR 650 Control Head DepthPower On/Off Key Functions OverviewUnits Set UnitsShallow Alarm Set Shallow Alarm IconDeep Alarm Set Deep Alarm IconNegativeOffset NumberIcon PostiveOffset NumberIconTransducer Maintenance MaintenanceHDR 650 Maintenance Troubleshooting HDR 650 Doesnt Power UpNo Bottom Reading on the Display No Continuous Depth Display in Very Shallow WaterScreen Fades, Images are not Sharp Bottom Reading Disappears During a Hard TurnYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Specifications Contact Humminbird