Humminbird HDR 650 manual Set Shallow Alarm Icon

Page 37

Shallow Alarm

The Shallow Alarm will sound when the measured depth is less than the setting.

1.Press the MENU key until the Shallow Alarm icon is displayed and flashing on the screen.

Set

Shallow Alarm Icon

2.Press the UP or DOWN arrow key to change the setting.

(Off, 1 - 20 feet, .1 - 6 meters, or .1 - 3.2 fathoms; Default = Off)

NOTE: The maximum Shallow Alarm setting cannot meet or exceed the current Deep Alarm setting (see the Deep Alarm section).

3.After your selection is made, wait 5 seconds for the unit to return to normal operation. Your settings are saved automatically, and the Shallow icon will be visible on the display.

4.Alarm: If the depth of the water is less than the saved setting, the alarm will sound and the alarm icon will flash on the screen.

Mute: Press any key to mute the alarm.

Adjust: Press the MENU key and follow the instructionsin step 2 to adjust the alarm setting.

33	Operations

Image 37

Contents HDR 650 Installation Operations Manual Thank You Table of Contents Maintenance How Sonar Works Installation Overview Installing the HDR Cutting the Mounting Hole Locating the HDR 650 Mounting PositionHDR Face Plate Trim Ring Tabs Customizing and Assembling the HDRCollar Gasket DashboardView Installing the HDRHDR 650 Control Head Connecting to the Power Supply Installing the BuzzerBuzzer Inline Fuse Holder Installing the TransducerTransducer Installation Overview Locating the Transducer Mounting Position Transom Transducer InstallationRivets Strakes TransomHull StepRibDeadrise Angle LevelPreparing the Mounting Location 4th hole Mark Initial Assembling the Transducer and Initial MountingDrill Holes Bead Alignment Number Transom Angle Measured Distance Transom Angle in degrees MeasuredWeight DistanceRib Knuckle Beads RatchetBead Ratchet Snap the pivot arm down into place Trailingedge One click too low Leading edge One click too highRouting the Cable Transom Mount Transducer Installation Test and Finish the Installation Connecting the CableStoring Excess Cable Gathered at one location as shown See the illustration Storing Excess CableLevel Seam aligned with boat hull Rib Ratchet BeadTransom Mount Transducer Installation Locking Down the Transducer Optional Inside the Hull Transducer Installation Positioning the Transducer and Preferred Mounting Area Trial InstallationRouting the Cable Make sure the position of the transducer is marked Permanently Mounting the TransducerTrolling Motor Transducer Options Trolling Motor Transducer InstallationOperating the HDR Units Shallow Alarm Icon IndicatesHDR 650 Control Head DepthKey Functions Overview Power On/OffSet Units UnitsSet Shallow Alarm Icon Shallow AlarmSet Deep Alarm Icon Deep AlarmPostiveOffset NumberIcon NegativeOffset NumberIconHDR 650 Maintenance MaintenanceTransducer Maintenance HDR 650 Doesnt Power Up TroubleshootingNo Continuous Depth Display in Very Shallow Water No Bottom Reading on the DisplayScreen Fades, Images are not Sharp Bottom Reading Disappears During a Hard TurnYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Specifications Contact Humminbird