Emerson 788 DVC manual Connections, Valve Capacity, Flow vs. Pressure Drop See Figure

Page 18
INMETRO Certification:
- Certificate Number:
- INMETRO Marking:

D E C 2012

DANIELTM MODEL 788DVC DIGITAL CONTROL VALVES

NCC 12.1244 X

Ex d nC IIB T3 Gc

Ex d IIC T* Gb

*See Tables 1 and 2 in the certificate for temperature range details.

Special condition for safe use: When the digital control valve is assembled with solenoid models 80174, 80173, 80143, 80144, HP80143, 8014G2 and F8003G1, the temperature of the process fluid must not be greater than 40°C.

Connections

2" through 6" ANSI flanged

Valve Capacity

Valve Size

2"

3"

4"

6"

8"

Cv* - gpm

86

186

309

688

1296

*Cv based on valve full open using water at 60/F (16/C)

For Valve Flow vs. Pressure Loss see Figure 3-1. Consult manual 3-9008-550, Capacity Charts for valve sizing.

Flow vs. Pressure Drop (See Figure 3-1)

Curve A - Wide open valves with no spring resistance.

Applicable to pilot operated valves with Y and Z ports vented to sump, atmosphere or pump station.

Curve B - Light main valve spring.

Applies only to On-Off valves, rate of flow control valves and check valves with ANSI 150 to 300 lb. flanges.

Curve C - Medium main valve spring.

Applies to all modulating control valves except rate of flow and valves using ANSI 600 lb. flanges.

Curve D- Heavy main valve spring.

Applies to all valves using ANSI 600 lb. flanges.

3-2

SPECIFICATIONS

Image 18
Contents DanielTM Model 788 DVC digital control valves This page intentionally left blank Important safety instructions Product operation personnel Safety signal words and symbols Safety alert symbolThis page intentionally left blank Page Warranty and limitation of liability Introduction Figures TablesDanieltm Model 788DVC Digital Control Valves Introduction Aggressive ProductsPrinciple of Operation Equipment DamageOperational Sequence Closed Position Open Control Position Open Position no control Pressure Class Do not exceed specifications listed belowSafe Working Temperature Ranges Maximum Safe Working PressureConnections Valve CapacityFlow vs. Pressure Drop See Figure Flow vs Pressure Loss Cylinder Head Pressure/Temperature RatingsMaterials of Construction Main Valve Body Main Valve CylinderTubing Astm A352 LCC WCB Dimensions Valve Size 150# Ansi 300# Ansi No Indicator With Indicator Recommended Installation Instructions General Considerations as Applied to the DL8000 Personal Injury or Death AND/OR Property Damage Use equipment for its intended purposeTypical Application Top Loading Typical Application Bottom Loading Control Valve Configuration new for DL8000 Cylinder Assembly Removal All Daniel Valves Cylinder Disassembly Recommended Low Flow Set-point Cylinder Reassembly Cup-seal Replacement on Existing AP Option Piston RetrofitOption Assembly Danieltm Model 788DVC Digital Control Valves Personal Injury AND/OR Equipment Damage Danieltm Model 788DVC Digital Control Valves Troubleshooting Condition Probable Cause Correction Danieltm Model 788DVC Digital Control Valves Parts List Parts List 2, 3, 4, 6, 8 Sizes Recommended Spare Parts Valve Cylinder Assembly Decontamination/Cleaning Fluids Process Infectious Radioactive Explosive Pyrophoric Poison GasShipping Requirements Page W .em erson.com