2. INSTALLATION
2.6Initial Settings
Follow the procedures in this section to enter initial settings.
NOTICE
Improper menu settings may stop output of data and display the message "RATE ERROR." Be sure to enter correct data.
2.6.1Confirming satellite status; choosing mounting method
1. Turn on the processor unit and press the [MENU] key to show the menu.
MAIN MENU
|
|
| SATELLITE |
ALARMS |
|
| |
MESSAGES |
|
| DGPS |
GPS SETUP |
| I/O SETUP | |
SYS SETUP |
| INST MENU | |
SOFT VER. |
| ERASE | |
OTHERS |
| TRIP MENU | |
| |||
Main menu
2. Use the Omnipad (
) to choose “INST MENU” and press the [ENT] key.
INSTALLATION SETUP 
MOUNTING : FLOOR
DIRECTION : A
LANGUAGE : ENG
Installation setup menu
3.Confirm that “MOUNTING” is selected and press the [ENT] key.
4.Use the Omnipad to choose the mounting method: “FLOOR”, “WALL” or “INVERT” as appropriate.
5.Press the [ENT] key.
6.Choose “DIRECTION” and press the [ENT] key.
7.Use the Omnipad to choose mounting direction (“A ”, “B ”, “C” or “D”) as appropriate. Refer to section 2.3.1.
8.Press the [ENT] key.
9.Press the [SAT STATUS] key.
|
| Satellites used for | ||
|
| measurement | ||
| SAT TRACKING STATUS | |||
Satellites | TIMER 5 '52" |
| OK | |
| NO. GOOD STATUS | |||
being | GPS1 | 8 | 8 | D3D |
tracked | GPS2 | 7 | 7 | D3D |
| GPS3 | 8 | 8 | D3D |
"OK" displayed when the "GOOD" column shows that the number of satellites acquired is five or more.
"3D" shown when no beacon receiver is used.