If you are restoring a Zone Coordinator, go to the location of the coordinator. (You cannot restore a coordinator from the System Manager’s USB flash drive.) Connect the USB flash drive with the backed up configuration to the coordinator’s USB port.
7.Press Continue.
If no flash drive is found, the message No USB Drive OR a backup for this device was not found appears. Press Cancel, insert a flash drive that contains a valid backup image, and try again.
8.If a flash drive that contains a valid backup image is found, a summary screen of the backup image appears.
YK-SMU-0 - Restore from USB Flash Drive
A backup for this device was found on:
Volume Name: [Volume Name]
Date: [Date]
Select Continue to restore [name] to this configuration.
Warning: Restoring the configuration will replace the current configuration parameters with the
information on the USB drive.
Continue
Figure 73: Restore Confirmation Screen (System Manager)
FIG:VldRstrUSBScrn
9.Press Continue to start the restore process from the flash drive. The process takes no longer than 1 minute to complete.
While the restore is in progress, the message Restore in Progress - Please wait. Device will reset if restore completes without error appears. After the restore has completed successfully, the device restarts and the Home screen appears in a few moments. If the restore failed, a message appears to describe what you can do.
10.Remove the flash drive and store it in a safe location.
System Manager/Zone Coordinator User’s Manual | 93 |