Multiple Phones Dead: No Dial Tone or Lights
Possible Cause 1: The LED on one system module is out.
What to do: If the green LED on the front of a module is out, try reseating the module in the control unit.
■If the LED lights, the problem is corrected.
■If the problem remains, call the hotline.*
Possible Cause 2: The green LEDs on several system modules are out.
What to do: If the LEDs on the front of several system modules are out, try reseating the leftmost module of the ones with the lights out (see “Replacing System Modules” in the PARTNER II Communications System Installation guide).
■If the LEDs light, the problem is corrected.
■If the problem remains, call the hotline.*
Other Problems with System
This procedure resets the system. Use it when you have any problems that are not covered elsewhere in this chapter. The following procedure disconnects all calls in progress, but does not erase any system settings.
Possible Cause: System needs a hardware reset.
What to do: Unplug the control unit’s power cord from the wall. Wait 10 seconds, then plug it back in. If the problem remains, call the hotline.*
✽In the continental U.S., help is available at 1 800