Kenwood TS-590S manual Comparison of Bandpass Characteristics of MCFs

Page 12

1 RECEPTION

Following is a graph that provides the comparison between the performances of roofing filters.

Figure 1-5 Comparison of Bandpass Characteristics of MCFs

Figure 1-5 compares the band pass characteristics of a roofing filter of center frequency 73 MHz (gray line); and the roofing filters of the center frequency 11.374 MHz with bandwidth of 500 Hz (blue line) and with bandwidth of 2.7 kHz (orange line) that are both employed by the TS-590S.

Because the center frequency of the filters differ, graphs are overlapped at the center frequency. The frequency indicated as 0 kHz at the center of the Frequency [kHz] axis is the receive frequency.

It is apparent that when down conversion is active, large attenuation is achieved at frequencies other than the target signal.

Figure 1-6 Comparison of Dynamic Range Characteristics

Figure 1-6 shows a graph comparing the dynamic range characteristics of TS-590S and TS-480S (with CW filter) that are measured by changing the frequency spacing with the interfering signal.

6

CONTENTS

TS-590S

Image 12
Contents TS-590S About Copyright Copyright of this Manual and SoftwareAbout Trademarks and Intellectual Properties Other RestrictionsContents Optional Accessory Product Planning Objectives Development Spirit Reception Type of ConversionReception Block diagram Down Conversion Down ConversionMCF Hints and Tips Comparison of Bandpass Characteristics of MCFs Measurement Conditions Up Conversion Dynamic Range in the 50 MHz BandRX Auxiliary Circuits CN101 CN102 CN103 Transmission Kenwood Traditional Transmitting CircuitryIf Circuits FET Final CircuitTransmission Remote Connector High-speed Relay-controlled Antenna TunerMenu N o or N o 1 or DRV Terminal Transmission Output Characteristics of DRV Terminal at 136 kHz and 0 dBm Transmission Comparison C/N Characteristics Local OscillatorDSP Multipurpose 32-bit Floating Point DSPAdvanced AGC Control via if Digital Processing DSPControl Block Diagram of IF-AGC Interference Elimination Within AGC Loop Digital if FilterTypes of Digital if Filters LOW CUTManual Notch Filter and Auto Notch Filter Digital Noise Blanker NB2 Demodulation Modulation Beat Cancel AF Processing DSP-based Auxiliary Circuits for RXNoise Blanker NB2 if Processing Overview of Noise Reduction 11 NB2 Inactive4 NR1 Spectral Subtraction Method AF Processing 13 Conceptual Scheme of NR1 Based on Spectral SubtractionAudio spectrum components swamped by noise 5 NR1 Based on a Line Enhancer AF Processing 16 NR1 Line Enhancer Method Inactive6 NR2 AF Processing 18 NR2 InactiveDSP-based Auxiliary Circuits for TX Speech Processor AF ProcessingDSP-based Auxiliary Circuits Common to TX/RX TX Equalizer & RX Equalizer AF ProcessingSoftware Enhancing Operating Pleasure Extended Data-mode Related FunctionsDrive Out Software Enhancing Operating PleasureSingle Button Toggles if Filters between a and B Operation in the 135 kHz BandMode Selection of Built-in Electronic Keyer Power-on MessageDouble Function Keys and Hold Time Selection Quick Memory Function Cross Tone FunctionPF Keys MIC CN Expansion of Voice Guide Function Optional VGS-1 Required Easy Updating of Firmware Projections on the Rear PanelA Sketch of the TS-590S Structural Features CoolingStructural Features Heat Sink Section LCD Amber and GreenMain Control Knob Main Control KnobSystem Configurations Controlling TS-590S from a PC using the COM ConnectorExpansive Application Software Windows Related SoftwareControlling TS-590S from a PC using the USB Connector ConnectionControlling TS-590S from a PC on a Remote Site Software HardwareBasic Specifications Inherited from ARCP-480 User InterfacesKNS Kenwood Network Command System Menu FunctionKNS Welcome Message Visual Scan Audio EqualizerBasic Specifications Inherited from ARHP-10 ARHP-590 Amateur Radio Host Program FreewareNew ARUA-10 USB Audio Controller Freeware Disabling AF Gain Control from ARCP-590Setup Basic FunctionsOperation Adjusting Volume Automatic Execution when Windows StartsStarting and Stopping ARUA-10 New ARVP-10H Amateur Radio VoIP Program Freeware 12 Main Window of ARVP-10HSetup of ARVP-10H Host Station Making ARVP-10H host station Online or OfflineSetup of ARVP-10R remote station Connecting and Disconnecting ARVP-10R Remote StationNew Virtual COM Port Driver 16 Device ManagerOptional Accessory PS-60 Regulated DC Power SupplyRectifier Circuit Comparing Rectification WaveformsPage Revision 1.00 May 15
Related manuals
Manual 92 pages 51.35 Kb