Kenwood TS-590S manual New ARUA-10 USB Audio Controller Freeware

Page 66

8 EXPANSIVE APPLICATION SOFTWARE

ARHP-590 allows a user to check the operating status of ARHP-590 and TS-590S even after minimized. You can check the status of the power of the TS-590S (Power ON or Power OFF) and your connection and transmission statuses.

Figure 8-9 Checking the Operating Status

8.4.3 KNS (Kenwood Network Command System)

For details of Kenwood Network Command System, refer to 8.3.3. KNS (Kenwood Network Command System).

8.4.4 Disabling AF Gain Control from ARCP-590

ARHP-590 has a capability to disable the AF gain control from the ARCP-590. While AF gain is controlled from ARCP-590, the audio volume of the TS-590S may be adjusted in an unexpected way. Therefore, we have added a function to disable this control.

To enable this function, from the Tool pulldown menu, select “Setup” and click on the Prohibits control of AF gain from ARCP-590checkbox.

8.5 New ARUA-10 (USB Audio Controller) Freeware

We have released ARUA-10, the USB audio control software to allow the PC’s microphone and speaker to be used in place those of the TS-590S.

ARUA-10 is available free and can be downloaded from Kenwood’s website. URLs from which ARUA-10 can be downloaded: http://www.kenwood.com/i/products/info/amateur/software_download.html Refer also to “TS-590S USB Audio Setting Manual” on the Kenwood’s website.

Caution:

For USB audio, time delay is unavoidable due to its operating principle. Therefore, USB audio cannot be used for a latency- critical application (e.g. operations in a contest or pileup where a quick response is essential).

During the operation with KNS over a network connection, ARUA-10 is not required.

60

CONTENTS

TS-590S

Image 66
Contents TS-590S About Trademarks and Intellectual Properties About CopyrightCopyright of this Manual and Software Other RestrictionsContents Optional Accessory Product Planning Objectives Development Spirit Reception Type of ConversionReception Block diagram Down Conversion Down ConversionMCF Hints and Tips Comparison of Bandpass Characteristics of MCFs Measurement Conditions Up Conversion Dynamic Range in the 50 MHz BandRX Auxiliary Circuits CN101 CN102 CN103 If Circuits TransmissionKenwood Traditional Transmitting Circuitry FET Final CircuitTransmission Remote Connector High-speed Relay-controlled Antenna TunerMenu N o or N o 1 or DRV Terminal Transmission Output Characteristics of DRV Terminal at 136 kHz and 0 dBm Transmission Comparison C/N Characteristics Local OscillatorDSP Multipurpose 32-bit Floating Point DSPAdvanced AGC Control via if Digital Processing DSPControl Block Diagram of IF-AGC Interference Elimination Within AGC Loop Digital if FilterTypes of Digital if Filters LOW CUTManual Notch Filter and Auto Notch Filter Digital Noise Blanker NB2 Demodulation Modulation Beat Cancel AF Processing DSP-based Auxiliary Circuits for RXNoise Blanker NB2 if Processing Overview of Noise Reduction 11 NB2 Inactive4 NR1 Spectral Subtraction Method AF Processing 13 Conceptual Scheme of NR1 Based on Spectral SubtractionAudio spectrum components swamped by noise 5 NR1 Based on a Line Enhancer AF Processing 16 NR1 Line Enhancer Method Inactive6 NR2 AF Processing 18 NR2 InactiveDSP-based Auxiliary Circuits for TX Speech Processor AF ProcessingDSP-based Auxiliary Circuits Common to TX/RX TX Equalizer & RX Equalizer AF ProcessingSoftware Enhancing Operating Pleasure Extended Data-mode Related FunctionsDrive Out Software Enhancing Operating PleasureSingle Button Toggles if Filters between a and B Operation in the 135 kHz BandMode Selection of Built-in Electronic Keyer Power-on MessageDouble Function Keys and Hold Time Selection Quick Memory Function Cross Tone FunctionPF Keys MIC CN Expansion of Voice Guide Function Optional VGS-1 Required Easy Updating of Firmware Projections on the Rear PanelA Sketch of the TS-590S Structural Features CoolingStructural Features Heat Sink Section LCD Amber and GreenMain Control Knob Main Control KnobExpansive Application Software System ConfigurationsControlling TS-590S from a PC using the COM Connector Windows Related SoftwareControlling TS-590S from a PC using the USB Connector ConnectionControlling TS-590S from a PC on a Remote Site Software HardwareBasic Specifications Inherited from ARCP-480 User InterfacesKNS Kenwood Network Command System Menu FunctionKNS Welcome Message Visual Scan Audio EqualizerBasic Specifications Inherited from ARHP-10 ARHP-590 Amateur Radio Host Program FreewareNew ARUA-10 USB Audio Controller Freeware Disabling AF Gain Control from ARCP-590Setup Basic FunctionsOperation Adjusting Volume Automatic Execution when Windows StartsStarting and Stopping ARUA-10 New ARVP-10H Amateur Radio VoIP Program Freeware 12 Main Window of ARVP-10HSetup of ARVP-10H Host Station Making ARVP-10H host station Online or OfflineSetup of ARVP-10R remote station Connecting and Disconnecting ARVP-10R Remote StationNew Virtual COM Port Driver 16 Device ManagerOptional Accessory PS-60 Regulated DC Power SupplyRectifier Circuit Comparing Rectification WaveformsPage Revision 1.00 May 15
Related manuals
Manual 92 pages 51.35 Kb