Kenwood TS-590S manual Optional Accessory, PS-60 Regulated DC Power Supply

Page 73

9 OPTIONAL ACCESSORY

9.1 PS-60 Regulated DC Power Supply

PS-60 is a regulated DC power supply designed for amateur transceivers.

The power supply adopts a switching module that accepts the input AC Voltage in the range from 90 V to 264 V. Though the power supply unit is compact in size (W 173.5 mm x H 95.5 mm x D 204.3

mmor W 6.83 inch x H 3.76 inch x D 8.04 inch) and lightweight (2.6 kg, or 5.73 lb), it has a capability to stably supply the power source enough to the transceivers including the TS-590S for 100-W class output power.

PS-60 has a higher load efficiency (85% typical with rated load current at 100 V) than the conventional transformer-type power supply units and conforms to your local energy regulations, enabling ecological and economical operation.

PS-60 received safety certificates in many countries in the world and incorporates the following protection features. Furthermore, the power supply has gone through safety and durability tests conducted according to Kenwood’s criteria to ensure your safe operation.

<Overcurrent Protection Feature>

If the load current exceeds 27 A, the output voltage droops and the output becomes intermittent to protect the main body.

<Overvoltage Protection Feature>

If the output voltage exceeds 18 V due to any failure, the supply of the power source stops so as to protect the connected device.

<Temperature Protection Feature>

The internal temperature is always monitored and if an aberrant value is detected, the supply of the power source stops so as to protect the main body.

The unit is equipped with a quiet cooling fan that starts running once the internal circuit detects the temperature exceeding a certain level.

The power supply unit has an external appearance design that matches the TS-590S and the front panel can be positioned on the same panel height of the TS-590S using the stand on the front bottom. (Since the length of the body differs, the angle of inclination is slightly different.)

Figure 9-1 PS-60

TS-590S

CONTENTS

67

Image 73
Contents TS-590S Copyright of this Manual and Software About CopyrightAbout Trademarks and Intellectual Properties Other RestrictionsContents Optional Accessory Product Planning Objectives Development Spirit Type of Conversion ReceptionReception Down Conversion Block diagram Down ConversionMCF Hints and Tips Comparison of Bandpass Characteristics of MCFs Measurement Conditions Dynamic Range in the 50 MHz Band Up ConversionRX Auxiliary Circuits CN101 CN102 CN103 Kenwood Traditional Transmitting Circuitry TransmissionIf Circuits FET Final CircuitTransmission High-speed Relay-controlled Antenna Tuner Remote ConnectorMenu N o or N o 1 or DRV Terminal Transmission Output Characteristics of DRV Terminal at 136 kHz and 0 dBm Transmission Local Oscillator Comparison C/N CharacteristicsMultipurpose 32-bit Floating Point DSP DSPDSP Advanced AGC Control via if Digital ProcessingControl Block Diagram of IF-AGC Digital if Filter Interference Elimination Within AGC LoopLOW CUT Types of Digital if FiltersManual Notch Filter and Auto Notch Filter Digital Noise Blanker NB2 Demodulation Modulation DSP-based Auxiliary Circuits for RX Beat Cancel AF ProcessingNoise Blanker NB2 if Processing 11 NB2 Inactive Overview of Noise Reduction13 Conceptual Scheme of NR1 Based on Spectral Subtraction 4 NR1 Spectral Subtraction Method AF ProcessingAudio spectrum components swamped by noise 16 NR1 Line Enhancer Method Inactive 5 NR1 Based on a Line Enhancer AF Processing18 NR2 Inactive 6 NR2 AF ProcessingSpeech Processor AF Processing DSP-based Auxiliary Circuits for TXTX Equalizer & RX Equalizer AF Processing DSP-based Auxiliary Circuits Common to TX/RXExtended Data-mode Related Functions Software Enhancing Operating PleasureSoftware Enhancing Operating Pleasure Drive OutOperation in the 135 kHz Band Single Button Toggles if Filters between a and BPower-on Message Mode Selection of Built-in Electronic KeyerDouble Function Keys and Hold Time Selection Cross Tone Function Quick Memory FunctionPF Keys MIC CN Expansion of Voice Guide Function Optional VGS-1 Required Projections on the Rear Panel Easy Updating of FirmwareA Sketch of the TS-590S Cooling Structural FeaturesStructural Features Heat Sink Section Amber and Green LCDMain Control Knob Main Control KnobControlling TS-590S from a PC using the COM Connector System ConfigurationsExpansive Application Software Windows Related SoftwareConnection Controlling TS-590S from a PC using the USB ConnectorSoftware Hardware Controlling TS-590S from a PC on a Remote SiteUser Interfaces Basic Specifications Inherited from ARCP-480Menu Function KNS Kenwood Network Command SystemKNS Welcome Message Audio Equalizer Visual ScanARHP-590 Amateur Radio Host Program Freeware Basic Specifications Inherited from ARHP-10Disabling AF Gain Control from ARCP-590 New ARUA-10 USB Audio Controller FreewareBasic Functions SetupOperation Automatic Execution when Windows Starts Adjusting VolumeStarting and Stopping ARUA-10 12 Main Window of ARVP-10H New ARVP-10H Amateur Radio VoIP Program FreewareMaking ARVP-10H host station Online or Offline Setup of ARVP-10H Host StationConnecting and Disconnecting ARVP-10R Remote Station Setup of ARVP-10R remote station16 Device Manager New Virtual COM Port DriverPS-60 Regulated DC Power Supply Optional AccessoryComparing Rectification Waveforms Rectifier CircuitPage Revision 1.00 May 15
Related manuals
Manual 92 pages 51.35 Kb