SCANNING
VFO SCANNING
The
Manual VFO Scan
1.Select the VFO mode by pressing the [VFO(PRI)] key, if necessary.
2.Press and hold in either the [(MHz)] or [(MHz)] key for one second to initiate upward or downward scanning, respectively.
3.If and when the scanner encounters a signal strong enough to open the squelch, the scanner will halt temporarily; the decimal point of the frequency display will blink during this “Pause” condition.
4.The scanner will then resume according to the
5.To cancel scanning, press the PTT switch or [VFO(PRI)] key.
Programmed VFO Scan
1.Select the VFO mode by pressing the [VFO(PRI)] key, if necessary.
2.Press and hold in the [VFO(PRI)] key for one second, then rotate the DIAL knob to select the bandwidth for the Programmed VFO scanner. Available selections are ±1
MHz, ±2 MHz, ±5 MHz,
ALL: The scanner will sweep all frequencies.
3.Press the [VFO(PRI)] key momentarily to save the new setting and exit to normal operation.
4.Press and hold in the [MR(SKIP)] key for one second to start scanning.
5. If and when the scanner encounters a signal strong enough to open the squelch, the scanner will halt temporarily; the decimal point of the frequency display will blink during this “Pause” condition.
6.The scanner will then resume according to the
7.To cancel scanning, press the PTT switch or the [VFO(PRI)] key.
When you start the Programmed VFO Scanner, the
direction (in this case, one click
| 37 |