MEMORY MODE
MEMORY OFFSET TUNING
Once you have recalled a particular memory channel, you may easily tune off that channel, as though you were in the “VFO” mode.
1. With the
2. Press the [MR(SKIP)] key momentarily to activate the “Memory Tuning” feature. The Memory Channel number will be replaced by “tun.” And if you have an
3. Rotate the DIAL knob, as desired, to tune to a new frequency. The synthesizer steps selected for VFO operation on the current band will be the steps used during Memory Tuning.
4. If you wish to return to the original memory frequency, just press the [MR(SKIP)] key momentarily. The display will revert to display of the
5.If you wish to store a new frequency set during Memory Tuning, just press and hold in the [F] key for one second, per normal memory storage procedure. The microproces- sor will automatically set itself to the
1)If you want to replace the original memory contents with those of the new frequency, be sure to rotate the DIAL knob to the original memory channel
number!
2)Any required CTCSS/DCS changes, or repeater offset modifications, must be done before storing the data into the new (or original) memory channel location.
DELETING MEMORIES
You may delete any of the memories (except for Memory Channel “1” and the Home Channel). The procedure for deleting a channel is quite simple.
1.Press the [VFO(PRI)] key, if needed, to enter the MR mode.
2.Press and hold in the [F] key for one second, then rotate the DIAL knob to select the memory channel to be deleted.
3.Press the [MR(SKIP)] key momentarily. The display will revert to memory channel #1. The
Important Notice! Once deleted, the channel data cannot be recovered!
32 |