Genius IC-M21 instruction manual Call channel programming, Automatic backlighting

Page 14

3 BASIC OPERATION

■Call channel programming

The call channel switch is used to select Channel 9 by de- fault, however, you can program your most often-used chan- nels in each channel group for quick recall.

q Push [DIAL] for 1 sec. to select the desired channel group (INT, USA) to be programmed.

w Push [16•C] for 1 sec. to select the call channel of the selected channel group.

- “CALL” and call channel number appear.

e Push [16•C] again for 3 sec. (until long beep changes to 2 short beeps) to enter call chan- nel programming condition.

-Call channel number and channel group to be programmed ﬂash.

r Push [Y]/[Z] to select the de- sired channel.

t Push [16•C] to program the dis- played channel as the call chan- nel.

- The call channel number and chan- nel group stop ﬂashing.

■Automatic backlighting

This function is convenient for nighttime operation. The auto- matic backlighting can be deactivated in SET mode. (p. 14)

•Push any key except for [PTT] to turn the backlighting ON.

-The backlighting is automatically turned OFF after 5 sec. of in- activity.

9

Image 14

Contents IM21 Clean the Transceiver Thoroughly with Fresh Case of EmergencyEquipment damage may occur Word Definition RwarningMay occur If disregarded, inconvenience only. No riskPage Table of Contents Privacy Operating RulesPriorities Radio licensesFront, top and side panels 0PTT Switch PTTPanel Description Battery Case Release Screw To remove the battery case If the seal is damaged, water resistant is not guaranteedScan Indicator p Transmit Indicator pBusy Indicator p Duplex Indicator3CHANNEL Number Readout 0BATTERY Indicator5TRANSMIT Power Indicator Channel Basic OperationChannel selection Call channelLock function Adjusting the squelch levelPush SQLMONI, then adjust the squelch level with Y/Z Appears while the lock function is usedSet squelch level Set output power Rotate OFF/VOL clockwise to turn power onPower on Set volume Push to Transmit Release to receive Receiving and transmittingPush any key except for PTT to turn the backlighting on Call channel programmingAutomatic backlighting Operation DUALWATCH/TRI-WATCHDescription DUALWATCH/TRI-WATCH SimulationPriority Scan Scan OperationScan types Normal ScanStarting a scan Setting tag channelsTo cancel the tag channel setting, push Scntag for 1 sec To stop the scan, push ScntagSET mode items SET ModeSET mode programming Beep tone bPAuto scan function AS Scan resume timer StScan indicator blinks while scanning Monitor action selection SqLCD contrast selection LC Auto power save function PSContrast of the LCD can be adjusted from 4 levels Self check function SCFunction Indication Switch Battery voltage indicator btMeter/RF meter indicator Sr Battery cautions Battery ChargingBattery charging Installing batteries Battery case Charging connectionsRapid charging with the BC-121N+AD-103 Optional battery chargersRapid charging with the BC-119N+AD-103 Flexible antenna Supplied Accessories and AttachmentsSupplied accessories HandstrapSwivel belt clip To attachTo remove Ceiver works properly or not TroubleshootingProblem Possible Cause Solution International channels Low power onlyChannel List Options Specifications and OptionsSpeciﬁcations 0560 Count on us Kamiminami, Hirano-ku, Osaka 547-0002 Japan