Genius IC-M21 Dualwatch/Tri-Watch, Description, Operation, DUALWATCH/TRI-WATCH Simulation

Page 15

DUALWATCH/TRI-WATCH 4

■Description

Dualwatch monitors Channel 16 while you are receiving an- other channel; tri-watch monitors Channel 16 and the call channel while receiving another channel.

DUALWATCH/TRI-WATCH SIMULATION

Call channel

DualwatchTri-watch

•If a signal is received on Channel 16, dualwatch/tri-watch pauses on Channel 16 until the signal disappears.

•If a signal is received on the call channel during tri-watch, tri- watch becomes dualwatch until the signal disappears.

•To transmit on the selected channel during dualwatch/tri-watch, push and hold [PTT].

■Operation

qSelect the desired operating channel.

wPush [DW•TRI] momentarily to start dualwatch; push [DW•TRI] for 1 sec. to start tri-watch.

-“DUAL” ﬂashes during dualwatch; “TRI” ﬂashes during tri-watch.

-Beep tones sound when a signal is received on Channel 16.

-Tri-watch becomes dualwatch when receiving a signal on the call channel.

eTo cancel dualwatch/tri-watch, push [DW•TRI] again.

[Example]: Operating tri-watch on INT Channel 07.

Push for 1 sec.

Tri-watch starts.

TRI

DW

Signal is received on call channel.

Signal received on Channel 16 takes priority.

Tri-watch resumes after the signal disappears.

10

Image 15

Contents IM21 Case of Emergency Clean the Transceiver Thoroughly with FreshIf disregarded, inconvenience only. No risk Word Definition RwarningMay occur Equipment damage may occurPage Table of Contents Radio licenses Operating RulesPriorities Privacy0PTT Switch PTT Panel DescriptionFront, top and side panels If the seal is damaged, water resistant is not guaranteed Battery Case Release Screw To remove the battery caseDuplex Indicator Transmit Indicator pBusy Indicator p Scan Indicator p0BATTERY Indicator 5TRANSMIT Power Indicator3CHANNEL Number Readout Call channel Basic OperationChannel selection ChannelAppears while the lock function is used Adjusting the squelch levelPush SQLMONI, then adjust the squelch level with Y/Z Lock functionReceiving and transmitting Rotate OFF/VOL clockwise to turn power onPower on Set volume Push to Transmit Release to receive Set squelch level Set output powerCall channel programming Automatic backlightingPush any key except for PTT to turn the backlighting on DUALWATCH/TRI-WATCH Simulation DUALWATCH/TRI-WATCHDescription OperationNormal Scan Scan OperationScan types Priority ScanTo stop the scan, push Scntag Setting tag channelsTo cancel the tag channel setting, push Scntag for 1 sec Starting a scanBeep tone bP SET ModeSET mode programming SET mode itemsMonitor action selection Sq Scan resume timer StScan indicator blinks while scanning Auto scan function ASSelf check function SC Auto power save function PSContrast of the LCD can be adjusted from 4 levels LCD contrast selection LCBattery voltage indicator bt Meter/RF meter indicator SrFunction Indication Switch Battery Charging Battery chargingBattery cautions Charging connections Installing batteries Battery caseOptional battery chargers Rapid charging with the BC-119N+AD-103Rapid charging with the BC-121N+AD-103 Handstrap Supplied Accessories and AttachmentsSupplied accessories Flexible antennaTo attach Swivel belt clipTo remove Troubleshooting Problem Possible Cause SolutionCeiver works properly or not Low power only Channel ListInternational channels Specifications and Options SpeciﬁcationsOptions 0560 Kamiminami, Hirano-ku, Osaka 547-0002 Japan Count on us