Genius IC-M21 instruction manual 0560

Page 31

DECLARATION OF CONFORMITY

We Icom Inc. Japan

1-1-32 Kamiminami, Hirano-ku,

Osaka 547-0003 Japan

Declare on our sole responsibility that this equipment complies with the essential requirements of the Radio and Telecommunications Terminal Equipment Directive, 1999/5/EC, and that any applicable Essential Test Suite measurements have been performed.

Kind of equipment: VHF MARINE TRANSCEIVER

Type-designation: iC- m21

0560

Place and date of issue

Version (where applicable):

This compliance is based on conformity with the following harmonised standards, specifications or documents:

i)	EN 301 178-2	V1.1.1 (2000-08)
ii)	EN 60945	1997
iii)	EN 60950	1992
iv)	EN 300 698-2	V1.1.1 ( 2000-8)
v)
vi)

Authorized representative name

T.Maebayashi General Manager

Signature

Image 31

Contents IM21 Case of Emergency Clean the Transceiver Thoroughly with FreshIf disregarded, inconvenience only. No risk Word Definition RwarningMay occur Equipment damage may occurPage Table of Contents Radio licenses Operating RulesPriorities PrivacyPanel Description 0PTT Switch PTTFront, top and side panels If the seal is damaged, water resistant is not guaranteed Battery Case Release Screw To remove the battery caseDuplex Indicator Transmit Indicator pBusy Indicator p Scan Indicator p5TRANSMIT Power Indicator 0BATTERY Indicator3CHANNEL Number Readout Call channel Basic OperationChannel selection ChannelAppears while the lock function is used Adjusting the squelch levelPush SQLMONI, then adjust the squelch level with Y/Z Lock functionReceiving and transmitting Rotate OFF/VOL clockwise to turn power onPower on Set volume Push to Transmit Release to receive Set squelch level Set output powerAutomatic backlighting Call channel programmingPush any key except for PTT to turn the backlighting on DUALWATCH/TRI-WATCH Simulation DUALWATCH/TRI-WATCHDescription OperationNormal Scan Scan OperationScan types Priority ScanTo stop the scan, push Scntag Setting tag channelsTo cancel the tag channel setting, push Scntag for 1 sec Starting a scanBeep tone bP SET ModeSET mode programming SET mode itemsMonitor action selection Sq Scan resume timer StScan indicator blinks while scanning Auto scan function ASSelf check function SC Auto power save function PSContrast of the LCD can be adjusted from 4 levels LCD contrast selection LCMeter/RF meter indicator Sr Battery voltage indicator btFunction Indication Switch Battery charging Battery ChargingBattery cautions Charging connections Installing batteries Battery caseRapid charging with the BC-119N+AD-103 Optional battery chargersRapid charging with the BC-121N+AD-103 Handstrap Supplied Accessories and AttachmentsSupplied accessories Flexible antennaTo attach Swivel belt clipTo remove Problem Possible Cause Solution TroubleshootingCeiver works properly or not Channel List Low power onlyInternational channels Speciﬁcations Specifications and OptionsOptions 0560 Kamiminami, Hirano-ku, Osaka 547-0002 Japan Count on us