Genius IC-M21 instruction manual Installing batteries Battery case, Charging connections

Page 23

(Not supplied with some versions)

ïCharging connections

qAttach the BC-150 to a ﬂat surface, such as desk or cabin, etc., if desired.

wConnect the AC adapter (BC-147E) as shown below.

eInsert the battery pack with/without the transceiver into the charger.

• The charge indicator lights green.

rCharge the battery pack approx. 8 hours, depending on the re- maining power condition.

CAUTION: DO NOT charge BP-224 more than 12 hours. Otherwise, BP-224 will be damaged. BP-224 must be charged for 8–12 hours only.

IC-M21

BP-224

Charge indicator

Lights green when

BP-224 (with/without

IC-M21) is inserted.

Supplied screws

AC adapter (BC-147E; Not

BATTERY CHARGING 7

■Installing batteries in the

battery case

When using a battery case attached to the transceiver, install 6 ⋅ AA(R6) size alkaline batteries as illustrated below.

qRemove the battery case from the transceiver. w Install 6 ⋅ AA(R6) size alkaline batteries.

•Be sure to observe the correct polarity.

CAUTION:

•When installing batteries, make sure they are all the same brand, type and capacity. Also, do not mix new and old batteries together.

•Keep battery contacts clean. It’s a good idea to clean bat- tery terminals once a week.

supplied with

BC-150

some versions)

18

Image 23

Contents IM21 Case of Emergency Clean the Transceiver Thoroughly with FreshIf disregarded, inconvenience only. No risk Word Definition RwarningMay occur Equipment damage may occurPage Table of Contents Radio licenses Operating RulesPriorities PrivacyFront, top and side panels 0PTT Switch PTTPanel Description If the seal is damaged, water resistant is not guaranteed Battery Case Release Screw To remove the battery caseDuplex Indicator Transmit Indicator pBusy Indicator p Scan Indicator p3CHANNEL Number Readout 0BATTERY Indicator5TRANSMIT Power Indicator Call channel Basic OperationChannel selection ChannelAppears while the lock function is used Adjusting the squelch levelPush SQLMONI, then adjust the squelch level with Y/Z Lock functionReceiving and transmitting Rotate OFF/VOL clockwise to turn power onPower on Set volume Push to Transmit Release to receive Set squelch level Set output powerPush any key except for PTT to turn the backlighting on Call channel programmingAutomatic backlighting DUALWATCH/TRI-WATCH Simulation DUALWATCH/TRI-WATCHDescription OperationNormal Scan Scan OperationScan types Priority ScanTo stop the scan, push Scntag Setting tag channelsTo cancel the tag channel setting, push Scntag for 1 sec Starting a scanBeep tone bP SET ModeSET mode programming SET mode itemsMonitor action selection Sq Scan resume timer StScan indicator blinks while scanning Auto scan function ASSelf check function SC Auto power save function PSContrast of the LCD can be adjusted from 4 levels LCD contrast selection LCFunction Indication Switch Battery voltage indicator btMeter/RF meter indicator Sr Battery cautions Battery ChargingBattery charging Charging connections Installing batteries Battery caseRapid charging with the BC-121N+AD-103 Optional battery chargersRapid charging with the BC-119N+AD-103 Handstrap Supplied Accessories and AttachmentsSupplied accessories Flexible antennaTo attach Swivel belt clipTo remove Ceiver works properly or not TroubleshootingProblem Possible Cause Solution International channels Low power onlyChannel List Options Specifications and OptionsSpeciﬁcations 0560 Kamiminami, Hirano-ku, Osaka 547-0002 Japan Count on us