Genius IC-M21 instruction manual Battery voltage indicator bt, Meter/RF meter indicator Sr

Page 21

DBattery voltage indicator “bt”

This function contains display or non-display settings of the voltage of the connected battery pack when the power is ON.

The voltage of the connected battery pack is displayed for 2 sec. after power is turned ON.

Battery voltage OFF (default)

DS-meter/RF meter indicator “Sr”

This function contains display or non-display setting of the S-meter/RF meter.

S-meter/RF meter OFF (default)

SET MODE 6

SET MODE LIST

Function

Indication

Switch

 

 

 

Beep tone

"bP"

OFF / Auto* / 1 10

Scan type selection

"Pr"

OFF / ON*

Scan resume timer

"St"

OFF* / ON

Auto scan function

"AS"

OFF* / ON

Monitor switch selection

"Sq"

Push* / Hold

Automatic backlighting

"bL"

ON* / OFF

LCD contrast selection

"LC"

3* / 1 4

Auto power save function

"PS"

ON* / OFF

Self check function

"SC"

OFF* / ON

Battery voltage indicator

"bt"

OFF* / ON

S-meter/RF meter indicator

"Sr"

OFF* / ON

 

 

 

 

 

*default setting

16

Image 21
Contents IM21 Case of Emergency Clean the Transceiver Thoroughly with FreshMay occur Word Definition RwarningEquipment damage may occur If disregarded, inconvenience only. No riskPage Table of Contents Priorities Operating RulesPrivacy Radio licenses0PTT Switch PTT Panel DescriptionFront, top and side panels If the seal is damaged, water resistant is not guaranteed Battery Case Release Screw To remove the battery caseBusy Indicator p Transmit Indicator pScan Indicator p Duplex Indicator0BATTERY Indicator 5TRANSMIT Power Indicator3CHANNEL Number Readout Channel selection Basic OperationChannel Call channelPush SQLMONI, then adjust the squelch level with Y/Z Adjusting the squelch levelLock function Appears while the lock function is usedPower on Set volume Push to Transmit Release to receive Rotate OFF/VOL clockwise to turn power onSet squelch level Set output power Receiving and transmittingCall channel programming Automatic backlightingPush any key except for PTT to turn the backlighting on Description DUALWATCH/TRI-WATCHOperation DUALWATCH/TRI-WATCH SimulationScan types Scan OperationPriority Scan Normal ScanTo cancel the tag channel setting, push Scntag for 1 sec Setting tag channelsStarting a scan To stop the scan, push ScntagSET mode programming SET ModeSET mode items Beep tone bPScan indicator blinks while scanning Scan resume timer StAuto scan function AS Monitor action selection SqContrast of the LCD can be adjusted from 4 levels Auto power save function PSLCD contrast selection LC Self check function SCBattery voltage indicator bt Meter/RF meter indicator SrFunction Indication Switch Battery Charging Battery chargingBattery cautions Charging connections Installing batteries Battery caseOptional battery chargers Rapid charging with the BC-119N+AD-103Rapid charging with the BC-121N+AD-103 Supplied accessories Supplied Accessories and AttachmentsFlexible antenna HandstrapTo attach Swivel belt clipTo remove Troubleshooting Problem Possible Cause SolutionCeiver works properly or not Low power only Channel ListInternational channels Specifications and Options SpecificationsOptions 0560 Kamiminami, Hirano-ku, Osaka 547-0002 Japan Count on us