Genius IC-M21 instruction manual Optional battery chargers, Rapid charging with the BC-119N+AD-103

Page 24

7 BATTERY CHARGING

■Optional battery chargers

DRapid charging with the BC-119N+AD-103

The optional BC-119N provides rapid charging of battery packs. The following are additionally required.

•AD-103

•An AC adapter (may be supplied with BC-119N depending on version).

IC-M21

BP-224

OPC-515L or

CP-17L

AD-103 charger adapter is installed in BC-119N.

AC adapter (BC-145E)

DRapid charging with the BC-121N+AD-103

The optional BC-121N allows up to 6 battery packs to be charged simultaneously. The following are additionally re- quired.

•Six AD-103.

•An AC adapter (BC-124) or the DC power cable (OPC-656).

IC-M21

BP-224

		AD-103 charger
	AC adapter	adapters are installed
	AC adapter	in each slot.
	(purchased	in each slot.
	(purchased
	separately)

DC power cable

(Connect with the DC power supply; 13.8 V/at least 7 A)

Image 24

Contents IM21 Clean the Transceiver Thoroughly with Fresh Case of EmergencyWord Definition Rwarning May occurEquipment damage may occur If disregarded, inconvenience only. No riskPage Table of Contents Operating Rules PrioritiesPrivacy Radio licenses0PTT Switch PTT Panel DescriptionFront, top and side panels Battery Case Release Screw To remove the battery case If the seal is damaged, water resistant is not guaranteedTransmit Indicator p Busy Indicator pScan Indicator p Duplex Indicator0BATTERY Indicator 5TRANSMIT Power Indicator3CHANNEL Number Readout Basic Operation Channel selectionChannel Call channelAdjusting the squelch level Push SQLMONI, then adjust the squelch level with Y/ZLock function Appears while the lock function is usedRotate OFF/VOL clockwise to turn power on Power on Set volume Push to Transmit Release to receiveSet squelch level Set output power Receiving and transmittingCall channel programming Automatic backlightingPush any key except for PTT to turn the backlighting on DUALWATCH/TRI-WATCH DescriptionOperation DUALWATCH/TRI-WATCH SimulationScan Operation Scan typesPriority Scan Normal ScanSetting tag channels To cancel the tag channel setting, push Scntag for 1 secStarting a scan To stop the scan, push ScntagSET Mode SET mode programmingSET mode items Beep tone bPScan resume timer St Scan indicator blinks while scanningAuto scan function AS Monitor action selection SqAuto power save function PS Contrast of the LCD can be adjusted from 4 levelsLCD contrast selection LC Self check function SCBattery voltage indicator bt Meter/RF meter indicator SrFunction Indication Switch Battery Charging Battery chargingBattery cautions Installing batteries Battery case Charging connectionsOptional battery chargers Rapid charging with the BC-119N+AD-103Rapid charging with the BC-121N+AD-103 Supplied Accessories and Attachments Supplied accessoriesFlexible antenna HandstrapSwivel belt clip To attachTo remove Troubleshooting Problem Possible Cause SolutionCeiver works properly or not Low power only Channel ListInternational channels Specifications and Options SpeciﬁcationsOptions 0560 Count on us Kamiminami, Hirano-ku, Osaka 547-0002 Japan