Genius IC-M21 instruction manual

Page 4

CAUTIONS

RWARNING! NEVER connect the transceiver to an AC outlet. This may pose a fire hazard or result in an electric shock.

RWARNING! NEVER hold the transceiver so that the antenna is very close to, or touching exposed parts of the body, especially the face or eyes, while transmitting. The transceiver will perform best if the microphone is 5 to 10 cm (2 to 4 inches) away from the lips and the transceiver is verti- cal.

NEVER connect the transceiver to a power source other than the BP-223 or BP-224. Such a connection will ruin the transceiver.

AVOID using or placing the transceiver in direct sunlight or in areas with temperatures below –15°C or above +55°C.

KEEP the transceiver out of the reach of children.

KEEP the transceiver at least 0.9 meter (3.0 ft) away from your vessel’s magnetic navigation compass.

Icom, Icom Inc. and are registered trademarks of Icom Incorporated (Japan) in the United States, United Kingdom, Germany, France, Spain, Russia and/or other countries.

BE CAREFUL! The transceiver’s right-side panel will become hot when operating continuously for long periods.

BE CAREFUL! The IC-M21 employs water resistant construction, which corresponds to JIS water resistant speci- fication, grade 7 (1 m; 3 ft depth for 30 min.). However, once the transceiver has been dropped, water resistant cannot be guaranteed due to the fact that the transceiver may be cracked, or the water resistant seal damaged, etc.

MAKE SURE the flexible antenna and battery pack are securely attached to the transceiver, and that the antenna and battery pack are dry before attachment. Exposing the inside of the transceiver to water will result in serious damage to the transceiver.

Versions of the IC-M21 which display the “CE” symbol on the serial number seal, comply with the essential requirements of the European Radio

and Telecommunication Terminal Directive 1999/5/EC.

This warning symbol indicates that this equipment oper- ates in non-harmonised frequency bands and/or may be sub- ject to licensing conditions in the country of use. Be sure to check that you have the correct version of this radio or the correct programing of this radio, to comply with national li- censing requirement.

iii

Page 3 Page 5
Image 4
Page 3 Page 5
Contents IM21 Clean the Transceiver Thoroughly with Fresh Case of EmergencyWord Definition Rwarning May occurEquipment damage may occur If disregarded, inconvenience only. No riskPage Table of Contents Operating Rules PrioritiesPrivacy Radio licensesPanel Description 0PTT Switch PTTFront, top and side panels Battery Case Release Screw To remove the battery case If the seal is damaged, water resistant is not guaranteedTransmit Indicator p Busy Indicator pScan Indicator p Duplex Indicator5TRANSMIT Power Indicator 0BATTERY Indicator3CHANNEL Number Readout Basic Operation Channel selectionChannel Call channelAdjusting the squelch level Push SQLMONI, then adjust the squelch level with Y/ZLock function Appears while the lock function is usedRotate OFF/VOL clockwise to turn power on Power on Set volume Push to Transmit Release to receiveSet squelch level Set output power Receiving and transmittingAutomatic backlighting Call channel programmingPush any key except for PTT to turn the backlighting on DUALWATCH/TRI-WATCH DescriptionOperation DUALWATCH/TRI-WATCH SimulationScan Operation Scan typesPriority Scan Normal ScanSetting tag channels To cancel the tag channel setting, push Scntag for 1 secStarting a scan To stop the scan, push ScntagSET Mode SET mode programmingSET mode items Beep tone bPScan resume timer St Scan indicator blinks while scanningAuto scan function AS Monitor action selection SqAuto power save function PS Contrast of the LCD can be adjusted from 4 levelsLCD contrast selection LC Self check function SCMeter/RF meter indicator Sr Battery voltage indicator btFunction Indication Switch Battery charging Battery ChargingBattery cautions Installing batteries Battery case Charging connectionsRapid charging with the BC-119N+AD-103 Optional battery chargersRapid charging with the BC-121N+AD-103 Supplied Accessories and Attachments Supplied accessoriesFlexible antenna HandstrapSwivel belt clip To attachTo remove Problem Possible Cause Solution TroubleshootingCeiver works properly or not Channel List Low power onlyInternational channels Specifications Specifications and OptionsOptions 0560 Count on us Kamiminami, Hirano-ku, Osaka 547-0002 Japan
Top Page Image Contents