Genius IC-M21 instruction manual Battery Case Release Screw To remove the battery case

Page 8

2 PANEL DESCRIPTION

ïBATTERY CASE RELEASE SCREW To remove the battery case:

Turn the screw counterclockwise, then pull the battery pack in the direction of the arrow as shown below.

To attach the battery case:

Insert the battery case in the IC-M21 completely, then turn the screw clockwise.

NOTE: When removing or attaching the battery case, use a coin or ﬂat-head screwdriver to loosen or tighten the bottom screw.

Screw position

when removing battery

LO	CK
LO
OPEN

Screw position

when attaching battery

LO	CK
LO
OPEN

CAUTION!:

When attaching or releasing a battery pack, make sure the rubber seal is set in the groove of the battery pack/case correctly. If the seal is not neatly in the groove it may be damaged when attaching the battery pack/case.

If the seal is damaged, water resistant is not guaranteed.

NOTE:

When attaching a battery pack/case, make sure dust etc. does not adhere to the rubber seal. If dust etc. is on the seal when attaching a battery pack/case, the water resistant may be reduced.

Make sure both the rubber seal (purple) is set to the groove correctly and dust etc. does not adhere to it.

Correct position	Incorrect position
	Rubber seal
	Groove
Battery pack/case	Battery pack/case

3

Image 8

Contents IM21 Clean the Transceiver Thoroughly with Fresh Case of EmergencyWord Definition Rwarning May occurEquipment damage may occur If disregarded, inconvenience only. No riskPage Table of Contents Operating Rules PrioritiesPrivacy Radio licensesFront, top and side panels 0PTT Switch PTTPanel Description Battery Case Release Screw To remove the battery case If the seal is damaged, water resistant is not guaranteedTransmit Indicator p Busy Indicator pScan Indicator p Duplex Indicator3CHANNEL Number Readout 0BATTERY Indicator5TRANSMIT Power Indicator Basic Operation Channel selectionChannel Call channelAdjusting the squelch level Push SQLMONI, then adjust the squelch level with Y/ZLock function Appears while the lock function is usedRotate OFF/VOL clockwise to turn power on Power on Set volume Push to Transmit Release to receiveSet squelch level Set output power Receiving and transmittingPush any key except for PTT to turn the backlighting on Call channel programmingAutomatic backlighting DUALWATCH/TRI-WATCH DescriptionOperation DUALWATCH/TRI-WATCH SimulationScan Operation Scan typesPriority Scan Normal ScanSetting tag channels To cancel the tag channel setting, push Scntag for 1 secStarting a scan To stop the scan, push ScntagSET Mode SET mode programmingSET mode items Beep tone bPScan resume timer St Scan indicator blinks while scanningAuto scan function AS Monitor action selection SqAuto power save function PS Contrast of the LCD can be adjusted from 4 levelsLCD contrast selection LC Self check function SCFunction Indication Switch Battery voltage indicator btMeter/RF meter indicator Sr Battery cautions Battery ChargingBattery charging Installing batteries Battery case Charging connectionsRapid charging with the BC-121N+AD-103 Optional battery chargersRapid charging with the BC-119N+AD-103 Supplied Accessories and Attachments Supplied accessoriesFlexible antenna HandstrapSwivel belt clip To attachTo remove Ceiver works properly or not TroubleshootingProblem Possible Cause Solution International channels Low power onlyChannel List Options Specifications and OptionsSpeciﬁcations 0560 Count on us Kamiminami, Hirano-ku, Osaka 547-0002 Japan