5.Remove the lamp cover screw.
6.Remove the lamp cover in the direction of the arrow.
Lamp cover
9.Install a new lamp unit in position securely.
ENGLISH
10.Lock the lamp unit in place with the two screws removed in step 7. Press on the handle until it folds over and close the cover sheet.
7.Open the cover sheet and remove the two screws (slotted head screwdriver required) that lock down the lamp unit. Do not remove any other screws.
Cover sheet
8.Holding the handle and pull the lamp unit out toward your side.
Lamp unit
11.Install the lamp cover back in its original position and fasten with the fastening screw.
(a) |
| (b) | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
12.Plug in the video projector and turn on the power and project the image.
•If the lamp is replaced before reaching its 2000 hours lamp life, see “Reset Lamp Life” (☞ P.30).
•If the lamp is replaced after reaching its 2000 hours lamp life, see “Initialize the Lamp Life” (☞ P.34).
35