Chapter 3
3.Verify that the SCSI identification display on the tape drive is set to 0, See Figure 3.2. If it is not, use a paper clip (or similar nonmarking, pointed instrument) to press the buttons to increase or decrease the number. Press the upper button to decrease the number and the lower button to increase it.
Do not press the upper button after the number 0 is displayed, or the lower button after 7 is displayed. Attempting to move beyond these parameters will break the buttons.
Figure 3.2. SCSI Identification Display: Stand-Alone T800-Series
To change the SCSI identification on a T800-series tape drive, first power down the tape drive. The SCSI identification is read by the system when the tape drive is powered up. If you change the SCSI identification display after power-up, the new identification will not be registered by the tape drive. Any attempts to access the tape drive will result in an application error.
4.Verify that the single-ended SCSI terminator (part number JC-005TRM) is installed in the lower port on the rear of the tape drive. If it is not installed, connect it to the lower port and securely clip it to the tape drive, See Figure 3.3.
Install only a single-ended SCSI terminator on the tape drive. Do not install a differential terminator, as it could damage the tape drive and/or SCSI PCI card.
Figure 3.3. SCSI Terminator: Stand-Alone T800-Series
