Lucent Technologies PA-8500 manual Configuring the RSN and C419/C619 Modem

Chapter 5

Chapter 5

Configuring the RSN and C419/C619 Modem

This chapter describes how to configure the Remote Services Network (RSN). It contains the following sections.

Preparing to Configure the RSN

Configuring the RSN

Configuring the C419/C619 Modem

Completing and Verifying Configuration of the RSN

For more information on how to configure the RSN, see HP-UX Operating System: Fault Tolerant System Administration (R1004H-04-ST).

5.1 Preparing to Configure the RSN

After logging into the system as root (See Booting the System), perform the following steps to prepare to configure the RSN

1.Enter the following command to set the password for the user sracsx or sracs. The sracsx or sracs login name enables CAC personnel to log in remotely to the system. In particular, the sracsx login enables the CAC to examine and change values in your system. The sracs login provides a restricted shell that enables the CAC only to examine values in this system.

passwd sracs

or

passwd sracsx

2.The system prompts you for a password. Enter a new password, and then confirm the password at the subsequent prompt.

New password:

Re-enter new password:

3.Record the sracsx or sracs account password; you will enter the password in the installation report, as described later in this chapter.

5.2Configuring the RSN

Perform the following steps to configure the RSN using the rsnadmin command.

1.Execute the rsnon script as shown in the following example. This script enables the RSN to work properly.