Lucent Technologies PA-8500 manual Powering Up the T800-Series 2nd

Chapter 3

8.Turn on the power switch on the rear of each tape drive, See Figure 3.14. The green power light on each tape drive is illuminated and remains lit as long as the tape drive is receiving power. If the light does not illuminate, check to be sure that the power cables are securely connected.

Figure 3.14. Powering Up the T800-Series (2nd)

To change the SCSI identification on a T800-Series tape drive, first power down the tape drive. The SCSI identification is read by the system when the tape drive is powered up. If you change the SCSI identification display after power-up, the new identification will not be registered by the tape drive. Any attempts to access the tape drive will result in an application error.

9.If you installed the tape drives on an offline system, the tape drives will come online when you boot the system. (See Chapter 4 Booting the System.)

3.4Completing the Installation of Tape Drives on a Running System

]