3M 11000 operating instructions Installation and Operation

7-INSTALLATION AND OPERATION
7.1 Operating Conditions
						WARNING
The machine should operate in a dry and relatively
clean environment at 5° to 50°C. with clean dry					• To reduce the risk associated with
boxes-relative humidity between 0% and 80%
					muscle strain:
7.2 Space Requirements for Machine Operation					− Use the appropriate rigging and material
	and Maintenance Work				handling equipment when lifting or
Minimum distance from wall (Figure 7-1):					repositioning this equipment.
					− Use proper body mechanics when
A	= 1.0m. (39.4 inches)				removing or installing taping heads that are
B	= 0.7m. (27.6 inches)				moderately heavy or may be considered
Minimum height = 2.7m. (106.3 inches)					awkward to lift.
					Bed Height :
		B
					he infeed conveyor is equipped with four (4)
					adjustable legs that are located at the corners of
					the frame. The legs can be adjusted to obtain
					different conveyor bed heights from 585mm [23 inch]
					minimum to 715mm [28.1 inch] maximum. Refer
					to Figure 7-3 and the Specification Section.
					1. Block up the conveyor frame to allow
					adequate leg adjustment.
					2. Loosen, but do not remove, two
				Figure 7-1	M8 x 16mm socket screws in one leg. Adjust
		A
					the leg length for the desired bed height.
					Retighten the two (2) screws to secure the
					leg. Adjust all four (4) legs equally.
			WARNING
	• To reduce the risk associated with					M8 x 16
	mechanical and electrical hazards:					Socket Head
	− Read, understand, and follow all safety and					Screws
	operating instructions before operating or
	servicing the Infeed Conveyor/Case Sealer.

7.3Machine Positioning / Bed Height

Figure 7-2

Adjustable

Leg

Figure 7-3

a80f-if-NA 17 2011 June