Seagate FR-A7AY Analog signal adjustment Pr , Pr , Pr , Pr, When Pr = 0 When Pr = 10

Page 24

EXTENSION ANALOG OUTPUT

4.5.4Analog signal adjustment [Pr. 307, Pr. 308, Pr. 311, Pr. 312]

Use Pr. 307 or Pr. 311 to set for zero analog output (meter points 0).

In addition, use Pr. 308 or Pr. 312 to set for maximum analog output (full-scale).

Use Pr. 307 to set the value for zero analog output and Pr. 308 for maximum analog output when outputting the same signal from terminals AM0 and AM1.

Use Pr. 307(AM1) and Pr. 311(AM0) to set the value for zero analog output and Pr. 308(AM1) and Pr. 312(AM0) for maximum analog output when outputting different signals from terminals AM0 and AM1. (Refer to page 15.)

		When Pr. 309 = 0, 1		When Pr. 309 = 10, 11
	Analog output	Output signal value (Pr. 308 or	Analog output	Analog output
	Current Voltage
			Current Voltage	value (Pr. 308 or
		Pr. 312) for maximum analog output
	(AM1) (AM0)		(AM1) (AM0)	Pr. 312) for

20mA 10V		20mA 10V	maximum
			output signal
0	Output signal	0	Output signal
0	value	0	value
	Output signal value (Pr. 307 or		Output signal value (Pr. 307 or
	Pr. 311) for zero analog output		Pr. 311) for zero output signal
	Pr. 311) for zero analog output

	REMARKS		REMARKS	= Pr. 308, Pr. 311 = Pr. 312, the output
	When Pr. 307	≥ Pr. 308, Pr. 311 ≥ Pr. 312, the output	When Pr. 307	= Pr. 308, Pr. 311 = Pr. 312, the output
	values at terminals AM0 and AM1 are always zero.		values at terminals AM0 and AM1 are values set in
			parameters always.

4

19

Image 24

Contents FR-A7AY This section is specifically about Safety matters Safety InstructionsInjury Prevention  Contents  Digital Output PRE-OPERATION Instructions Unpacking and Product ConfirmationPacking confirmation Parts Front viewRear view Terminal layoutSpecifications Output signalsMemo Installation and Wiring Pre-Installation InstructionsInstallation Procedure Remove the inverter front coverWiring Tightening Torque Cable Size30K or less 37K or more Name Setting Range Minimum Initial Refer to Number Parameter ListValue Parameter List Wiring Example Extension Analog OutputInternal Block Diagram Terminal Symbol Terminal Name Description TerminalsParameter Name Setting Range Minimum Initial Number Extension Analog Output Function Parameter ListAdjustment Procedure Setting Calibration of meter StartExtension Analog Output Output signal setting Types of Monitor Increments Full-Scale ValueAnalog signal adjustment Pr , Pr , Pr , Pr When Pr = 0 When Pr = 10Instructions Digital Output Digital Output Name Initial Value Setting Range Digital Output Function Parameter ListOutput Signal List SettingFunction Setting FunctionRO2 Revisions Print Date Manual Number Revision