Seagate FR-A7AY instruction manual Installation Procedure, Remove the inverter front cover

Page 11

INSTALLATION AND WIRING

2.2 Installation Procedure

1)

Screw hole for option mounting (on earth plate)

Screw hole for option mounting

Inverter side option connector

3)

2)

1)Remove the inverter front cover.

2)Mount the hex-head screw for option mounting into the inverter screw hole (on earth plate). (size 5.5mm, tightening torque 0.56N⋅m to 0.75N⋅m)

3)Securely fit the connector of the plug-in option to the inverter connector along the guides.

4)Securely fix the both right and left sides of the plug-in option to the inverter with the accessory mounting screws. If the screw holes do not line-up, the connector may not have been plugged snugly. Check for loose plugging.

REMARKS

After removing two screws on the right and left places, remove the plug-in option.

Hex-head screw

4) Mounting

for option mounting

 

screws

(The plug-in option is easily removed if the control circuit terminal block is removed before.)

CAUTION

1.When the inverter can not recognize that the option unit is mounted due to improper installation, etc.,

" " (option alarm) is displayed.

2.Note that a hex-head screw for option mounting or mounting screw may drop during mounting and removal.

6

Image 11
Contents FR-A7AY Safety Instructions This section is specifically about Safety mattersInjury Prevention  Contents  Digital Output Packing confirmation PRE-OPERATION InstructionsUnpacking and Product Confirmation Terminal layout PartsFront view Rear viewOutput signals SpecificationsMemo Pre-Installation Instructions Installation and WiringRemove the inverter front cover Installation ProcedureTightening Torque Cable Size Wiring30K or less 37K or more Value Name Setting Range Minimum Initial Refer to NumberParameter List Parameter List Extension Analog Output Wiring ExampleInternal Block Diagram Terminals Terminal Symbol Terminal Name DescriptionExtension Analog Output Function Parameter List Parameter Name Setting Range Minimum Initial NumberSetting Adjustment ProcedureStart Calibration of meterExtension Analog Output Types of Monitor Increments Full-Scale Value Output signal settingWhen Pr = 0 When Pr = 10 Analog signal adjustment Pr , Pr , Pr , PrInstructions Digital Output Digital Output Digital Output Function Parameter List Name Initial Value Setting RangeFunction Output Signal ListSetting Function SettingRO2 Print Date Manual Number Revision Revisions