INSTALLATION AND WIRING
2.3 Wiring
(1)Strip off the sheath of the cable to wire.
Strip off the sheath about the size below. If the length of the sheath pealed is too long, a short circuit may occur among neighboring wires. If the length is too short, wires might come off.
Cable stripping size | Wire the stripped cable after twisting it to prevent it from becoming loose. | |
|
| In addition, do not solder it. |
|
| Use a bar type terminal as required. |
| 5mm | |
| ||
|
| |
REMARKS
Information on bar terminals
Introduced products (as of October, 2003): Phoenix Contact Co.,Ltd.
Terminal Screw | Bar Terminal Model | Bar Terminal Model | Wire Size (mm2) | |
Size | (with insulation sleeve) | (without insulation sleeve) | ||
| ||||
M2 | Al | A | 0.3 to 0.5 |
⋅Bar terminal crimping tool: CRIMPFOX ZA3 (Phoenix Contact Co., Ltd.)
When using the bar terminal (without insulation sleeve), use care so that the twisted wires do not come out.
(2) Loosen the terminal screw and insert the cable into the terminal.
Screw Size | Tightening Torque | Cable Size |
|
| Screwdriver | |
M2 | 0.22N⋅m to 0.25N⋅m | 0.3mm2 to 0.75mm2 | Small |
| ||
| ||||||
(Tip thickness: 0.4mm/tip width: 2.5mm ) | ||||||
|
|
| ||||
CAUTION
Undertightening can cause cable disconnection or malfunction. Overtightening can cause a short circuit or malfunction due to damage to the screw or unit.
2
7