Xantrex Technology Freedom SW 2000 user service For wire and breaker size information

Planning the Installation

	INVERTER AC SUB PANEL (TYPICAL)
IMPORTANT: Read Owner’s and Installation Guides
prior to installation.		HOT BUS	15 A	TO AC APPLIANCE
Always refer to local and national
				LOADS
electrical codes for proper wire and			20 A
breaker sizes prior to installation.

			2
3	OPTIONAL				Neutral
	GFCI duplex receptacle
	15 A output limit				GND
				MAIN ELECTRICAL PANEL
	4	HARDWIRE CONNECTIONS
		20 A MAX in inverter				MAIN
120 V AC OUT		30 A MAX In pass-through
		10 AWG
FSW 2000			1	30 A			HOT BUS
Inverter/Charger

120 V AC IN	4	10 AWG*
5		HOT = BLACK
	NEUTRAL = WHITE
4/0 AWG	8 AWG Chassis GND	GND = GREEN/Bare
	6	Neutral
250 A fuse**
12 volt		GND
Battery (Bank)

** Class T or equivalent

Figure 3 Wiring and Breakers Block Diagram

For wire and breaker size information:

1.See “AC Input Protection” on page 7. 2.See “AC Output Protection” on page 8. 3.See “GFCI Requirements” on page 8. 4.See “AC Wiring” on page 9.

5.See “DC Cabling” on page 11. 6.See “DC Grounding” on page 11.

FROM SHORE OR

GENERATOR POWER

6 Freedom SW 2000 Installation Guide