Installing the Inverter/Charger
Mounting to the Side of the Battery Case
To mount the sensor on the battery case:
Figure 9 BTS Mounted on the Battery Case
1.Select the battery to be monitored.
The BTS should be connected to the battery bank that is directly connected to the inverter/charger.
2.Select a side suitable for attaching the sensor.
The surface where the sensor is to be mounted must be flat and free from reinforcing ribs or other raised features. This surface must be in direct internal contact with the battery electrolyte. Do not install the sensor near the top of the battery or on the battery’s top surface.
3.Clean the selected area thoroughly to remove any oil or grease that could prevent the sensor from adhering to the battery case. Allow the battery case to dry thoroughly.
4.Peel the protective backing from the
5.Press the sensor firmly against the clean side of the battery to fix it in place, as shown in Figure 9.
6.Route the sensor cable to the inverter/charger and plug it into the Battery Temp. jack, as shown in Figure 8. Secure the cable along its length.
32 | Freedom SW 2000 Installation Guide |