Xantrex Technology Freedom SW 2000 user service Output AC Wire Size

Page 37

Table 4 Output AC Wire Size

Wire Size	No. 10 AWG
Color Coding	L: black:
	N: white
	G: green

6.Tighten the terminal screws. Leave some slack wire inside the wiring box.

7.Secure the strain-relief clamp on the AC output cable jacket.

8.Attach the wiring compartment cover panel and tighten the four screws.

9.Connect the outgoing AC wires to an AC load panel equipped with circuit breakers.

Installing the Inverter/Charger

This guide for use by qualified installers only.

975-0527-01-01

23

Image 37

Contents Freedom SW Sine Wave Inverter/Charger Page This guide for use by qualified installers only Statement of Hazard About This GuideRelated Information Electrical Shock Hazard Important Safety InstructionsExplosion Hazard Fire and Burn HazardPrecautions When Working With Batteries Exposure to Chemicals and Gases Hazard Precautions When Preparing to ChargeRisk of Damage to the INVERTER/CHARGER Limitations on USE RegulatoryContents Page Cabling and Hook-up Configurations Page Introduction Materials List Materials ListBefore You Begin the Installation Installation InformationInstallation Codes Electrical Shock and Fire HazardsTwo Key Performance Factors Planning the InstallationSize and Length of DC Cables Mounting Location of the Freedom SWSample Vehicle Electrical System Configuration AC and DC Components including wire and breaker sizesFor wire and breaker size information AC Input AC ComponentsAC Output AC LoadsAC Output Protection Distribution PanelsGfci Requirements Tested GFCIsAC Output Neutral Bonding AC WiringBatteries DC ComponentsDC Disconnects and Over-Current Devices DC Grounding DC CablingHeavy Load Tools Installation Tools and MaterialsMaterials Overview Installing the Inverter/ChargerFire and Explosion Hazard Choosing a Location for the Inverter/ChargerHeat Hazard Battery acid BatterySafe Close toConsiderations Mounting the Inverter/ChargerTo mount the inverter/charger Approved Mounting Orientation Orientation? Comment Approved Mounting Orientation Orientation? General AC Wiring Considerations Connecting the AC Input and AC Output WiresFIRE, Electrical SHOCK, and Energy Hazards Equipment Damage Connecting AC Input WiresDamage other equipment To make the AC input connectionsConnecting AC Output Wires Output AC Wire Size DC Connection Precautions Connecting the DC CablesPreparing the Cables To prepare the DC cablesElectrical Shock and Fire Hazard Guidelines for Routing the DC CablesFire Hazard Connecting the DC Cables to the Inverter/ChargerEquipment Damage DUE to Reverse Polarity DC Terminal Covers To connect the chassis ground 2000Mounting Options Connecting the Battery Temperature Sensor BTSTo mount the sensor on the negative battery terminal Mounting to the Negative Battery TerminalConnecting the BTS Cable to BTS Jack To mount the sensor on the battery case Mounting to the Side of the Battery CasePerforming Checks Prior to Initial Start-Up Testing in Invert Mode Testing Your InstallationInstallation Complete Testing in Charge ModeInverter/Charger Physical Specifications Battery Bank Sizing Battery InformationCalculating Battery Size Calculate Battery SizeBattery Information Battery Bank Sizing Worksheet Battery BanksRestrictions on Motor Size = Total watt-hours of AC load between charges Parallel Connection Cabling and Hook-up ConfigurationsBatteries Connected in Series Series ConnectionBatteries in Series-Parallel Connections Series-Parallel ConnectionsPage Page Xantrex Technology Inc