7.3Connecting cables
Fabricate the cables as shown in the section “4.4 Fabricating Cable, Assembling connectors.” Connect the cables, referring to the interconnection diagrams at the back of this manual.
RGB port panel
Port for monitor
Cable entrance
DISPLAY
R
G
B
15P
H
Power supply port
V
BNC
FUSE 5A
HC
2 3
100 VAC
50/60Hz
2A1 GND
Ground terminal
Processor unit (rear panel)
Protective earth
Attach protective earth cable
CAUTION
Securely attach protective earth to the ship's body.
The protective earth is required to prevent electrical shock.
Connectors for Monitor
There are two kinds of video signal ports:
•
•BNC connector: Use five 75 Ω coaxial cables (shipyard supply). The coaxial cables are preferred in case of longer than 10 m cable run between the processor unit and monitor.
The following modification is required to use the BNC connectors.
1.Dismount the RGB port panel at the rear of the processor unit.
2.Confirming the label attached to each BNC connector, connect each connector to its corresponding port.
3.Mount the RGB port panel.
43