4. WAYPOINTS, NAV LINES
4.5.7Setting up navigation lines
Navigation lines may be set up as follows:
1. Press the [NAV MENU] and [3] keys.
[NAV LINE]
1 [NAV INFORMATION(1)]
2 NAV LINE
OFF/ON
3 NAV LINE NO.
ÆÆÆ
4 NAV WIDTH OFF/ON 0.00NM
5
6 WPT NO.
**ÆÆÆ
( ) Æ(**)
7 NAV LINE DATA VIDEO PLOTTER/NAVAID
8 ARRIVAL ALARM OFF/ON *.**NM
9
NAV LINE menu
2.Press the [2] key to choose NAV LINE ON.
3.Press the [7] key.
4.Press the [7] key to choose NAV LINE DATA. Choose VIDEO PLOTTER for internally generated navigation width data or NAVAID for external navaid generated data. Press the [ENTER] key.
Note: For NAVAID, set USED WPL on the NAV INFORMATION 3 menu to NAV LINE. (Not available on
5.Press the [4] key to set NAV WIDTH to ON and press the [ENTER] key.
6.Enter lane width (in nautical miles) and then press the [ENTER] key.
7.To enter waypoint where to head or skip current waypoint and head to next waypoint, press the [6] key and enter waypoint number.
8.Press the [ENTER] key. For example, you are following waypoints 11, 12, 13 and 14 on a nav line. Then, to head to waypoint 12, display (11)→●12→(13) →(14).
9.To get the audio alarm when you near a waypoint, press the [8] key to choose ARRIVAL ALARM.
10.Press the [8] key to choose ON and press the [ENTER] key.
11.Key in the alarm range and then press the [ENTER] key. For alarm range less than 0.5 nm, waypoints are automatically switched when your ship is 0.5 nm from a waypoint, therefore the audio alarm does not sound.
22