Pioneer X-MT2000 Cleaning external surfaces, Moving the unit, Magnetic shielding of speakers

Page 29

7 Additional Information

Cleaning external surfaces

To clean this unit, wipe with a soft, dry cloth. For stubborn dirt, wet a soft cloth with a mild detergent solution made by diluting one part detergent to 5 or 6 parts water, wring well, then wipe off the dirt. Use a dry cloth to wipe the surface dry. Do not use volatile liquids such as benzene and thinner which may damage the surfaces.

English

Moving the unit

Before moving the unit, remove all discs loaded. Moving it with discs loaded can damage the unit.

1

If transporting the unit you should also replace the transport stopper to fix the disc tray securely in place.

1Press CD SELECT 3.

2Press OPEN/CLOSE 0 for disc 1.

3Thread the tip of the stopper through the hole on the front left of the disc tray, from the top.

4 Bring the tip round and through the hole on the front of the stopper. Pull to make sure there is no slack.

5Bend the tip down flush with the stopper and fix it in place with tape.

6Press STANDBY/ON.

The disc tray should closed. Don’t press any other buttons.

7 Unplug the unit.

Magnetic shielding of speakers

The speaker system is not magnetically shielded. This means that if the speakers are placed very near a television set or monitor, you may see colour distortion in the picture. Move the speaker(s) further away from the television to solve the problem.

If you wish to connect speakers other than the ones supplied, use only speakers with a nominal impedance of between 6 Ω and 16 Ω. Refer to your speaker’s operating instructions if you’re unsure of their impedance before connecting them and switching on.

29

En

Image 29
Contents MT2000 Important Safety Instructions English Français English English Checking whats in the box Using this manualRemoving the transport stopper Putting the batteries in the remoteDonÕt Hints on installationAvoiding condensation problems Back panel Connecting the AM and FM antennasAM loop antenna Assemble the antenna as shown belowExternal AM antenna Connecting external antennasFM wire antenna Connect an outdoor FM antenna as shown below Connecting the speakersExternal FM antenna Connecting to other components Using a sub-wooferPower cord caution Plugging in to an AC outletDisc tray Front panelFluorescent display Character display DisplayRemote control range Remote controlSwitching on the clock in standby Setting the clockSwitch on Display shows AM 1200, with the hour blinkingPlaying CDs Load a disc into each disc tray Press Play Mode remote only to set the Play ModeListening to a connected component Listening to the radioImproving stereo FM sound Press FM/AM Tuner remoteProgramming a single disc playlist Programming the track orderProgramming a multi disc playlist Select the ALL play modeClearing a track from the playlist Adding a track to the playlistChecking and editing the playlist Erasing the playlistUsing repeat play Using random playWaking up to a CD Activating/deactivating the timerSetting the wake up time Sleeping to a CD Sleep OFF cancels the sleep timerListening to station presets Saving station presetsTune into the station you want to save as a preset Press Enter again to save the station as a presetRemember, things sound louder first thing in the morning Set the volumeWaking up to the radio or auxiliary component There are four settings Lights to show that the timer is now setSleeping to the radio Only to do thisHandling discs CD lens cleanerStoring discs Discs to avoidMoving the unit Cleaning external surfacesMagnetic shielding of speakers Disc tray should closed. Don’t press any other buttonsTroubleshooting Specifications Speaker System We Want You Listening For a Lifetime Mise en Service Commandes et AffichagesPrŽparatifs RaccordementTable des matires Utilisation de ce manuel Ce mode d’emploiExtraction du tampon de transport Retirez le tampon de transport en tirant dessusNe pas faire Suggestions pour lÕinstallationFaire Assemblez lÕantenne en suivant lÕillustration ci-dessous Le panneau arrireAntenne cadre AM Antenne AM externe Raccordement des antennes externesAntenne fil FM Antenne FM externe Raccordement des enceintesRaccordez l’antenne FM extérieure comme indiqué ci-dessous ‰ble coaxial 75 ΩBranchement ˆ une prise secteur Utilisation dÕun sub-woofer haut-parleur dÕextrme graveRaccordement dÕautres composants Plateau ˆ disque Timer Sert à régler le réveilAfficheur fluorescent Affichage de caractre AfficheurPortŽe de la tŽlŽcommande TŽlŽcommandeRŽglage de lÕhorloge Allumage de lÕhorloge dans le mode dÕattenteAllumez LÕaffichage montre TIME? Appuyez sur EnterLecture de CD Cercle interne Changement de lÕinformation affichŽe du disqueChargez un disque dans chaque plateau ˆ disque Ƒcoute de la radio Appuyez sur FM/AM Tuner sur tŽlŽcommandeƑcoute dÕun composant raccordŽ AmŽlioration du son FM stŽrŽoProgrammation de lÕordre des pistes SŽlectionnez le mode de lecture SingleSŽlectionnez CD Ajoutez plus de pistes au rŽpertoireRépétez l’opération 4 pour ajouter jusqu’à 32 pistes SŽlectionnez le mode de lecture ALLSuppression dÕune piste du rŽpertoire Ajout dÕune piste au rŽpertoireVŽrification et montage du rŽpertoire Effacement du rŽpertoireUtilisation de la lecture rŽpŽtŽe Utilisation de la lecture alŽatoireRŽglage de lÕheure du rŽveil Se rŽveiller au son dÕun CDActivation/dŽsactivation de la minuterie Minuterie de sommeil se remettra à zéro SÕendormir au son dÕun CDMŽmorisation de stations prŽrŽglŽes Appuyez sur FM/AM Tuner tŽlŽcommandeƑcoute de stations prŽrŽglŽes Accordez la station que vous souhaitez mŽmoriser commeRappelez-vous que le matin les sons sont plus élevés RŽglez le volumeSÕendormir au son de la radio Disques ˆ Žviter Manipulation des disquesRangement des disques Nettoyage des surfaces externes DŽplacement de lÕunitŽBlindage magnŽtique des enceintes DŽbranchez lÕunitŽGuide de dŽpannage SpŽcifications AccessoiresRŽcepteur CD StŽrŽo Section Amplificateur Section Lecteur de Disques CompactsSystme Acoustique Français DŽsactivation du mode de dŽmonstration Switching off the demo mode