Setting up the receiver
5 Use and to adjust the delay for each channel in turn, pressing ENTER to go to the next channel when you’re done.
Listen to the reference channel and use it to measure the target channel. Stand facing the two speakers with your arms outstretched pointing at each speaker. Try to make the two tones sound as if they are arriving simulta- neously at a position slightly in front of you and between your arm span.
Setting separate channel levels for listening modes
• Default setting: 0 dB
You can set relative channel levels from the listening position using the method below (this is similar to the
06
English Italiano
The test tone for channel delay is output in the same order as step 5:
R C LS
SW SB RS
After you have completed all the channels in your speaker setup, the volume level returns to normal and COMPLETE, then RESUME shows in the display.
The MCACC indicator then lights to show that MCACC setup is complete.
•Using the MCACC system to set up your speaker system will overwrite any previous settings you had for the STANDARD or ADVANCED SURROUND modes.
ADVANCED
STANDARD SURROUND
CH | LEVEL | TEST |
SELECT | TONE |
MASTER
VOLUME
1Press STANDARD or ADVANCED SURROUND.
2Press TEST TONE to output the test tone.
The test tone is output in the following order (depending on the speaker setting):
L C R 
RS
SW LS SB
•If you don’t hear a test tone from one of your speakers, please refer to Speaker setting on page 46 and
Français Deutsch Nederlands Español
53
En