
06Setting up the receiver
Function setting for VIDEO input
•VIDEO:1 – VIDEO:5 or TV – Matches the VIDEO function of the receiver with a numbered video input on the plasma display. For example, VIDEO:4 matches the VIDEO input with video input 4 on the plasma display.
Manually calibrating your listening area (MCACC)
VSX-D714/D814 only
You can use the Multichannel Acoustic Cali- bration (MCACC) system to fine tune your speaker levels and channel delay. These are calibrated according to the distance from your left front speaker to the listening posi- tion. You will hear a series of test tones that will allow you to set the speaker levels and channel delay to your liking. The advantage of doing this is that you can achieve an overall balance defined by the front speakers (the main speakers for home theater).
•These test tones can be loud, so take care that there is no one in the room who will be startled by the noise.
•You must complete the Speaker setting on page 46 before using the MCACC setup.
RECEIVER
ENTER
MCACC
SETUP
1Press RECEIVER.
2Press MCACC SETUP.
The MCACC system uses the left front speaker as a reference point to calibrate the speaker level and channel delay.
The front left speaker tone and the target speaker (the one that you’re trying to adjust) tone will sound in turns, so you can judge which needs to be louder.
3 Use and to adjust each channel level in turn, pressing ENTER to go to the next channel when you’re done.
The test tone is output in the following order (depending on the speaker setting):
R | C | LS |
SW | SB | RS |
4 Specify the distance from the front left speaker to your listening position using and then press ENTER.
52
En