1SOUND Menu, Atone Control, Cmute Level, 62 En

MANUAL SETUP

SOUND MENU

Use to manually adjust the various parameters related to the sound output.

SET MENU → MANUAL SETUP → SOUND MENU

1)SOUND MENU

. A)TONE CONTROL B)SUBWOOFER SET C)MUTE LEVEL D)AUDIO DELAY E)DD/DTS Dynamic Range F)TruBass

[p]/[p]:Up/Down [ENTER]:Enter

■TONE CONTROL (Tone control)

You can adjust the tonal quality of sound beams.

A)TONE CONTROL

-	+
. TREBLE;;;;;0dB	------
-	+
BASS;;;;;;;0dB	------
[p]/[p]:Up/Down [p]/[p]:Sel
[ENTER]:Return

TREBLE (Treble)

Use to adjust the high-frequency response.

Choices: –12 dB to +12 dB

Initial setting: 0 dB

BASS (Bass)

Use to adjust the low-frequency response.

Choices: –12 dB to +12 dB

Initial setting: 0 dB

■SUBWOOFER SET (Subwoofer settings)

Use to manually adjust the various subwoofer settings.

B)SUBWOOFER SET

. BASS OUT;;;;;FRONT

CROSS OVER;;;100Hz

LFE LEVEL;;;;;;0dB

DISTANCE;;;;;;3.0m

[p]/[p]:Up/Down [p]/[p]:Sel [ENTER]:Return

BASS OUT (Bass out)

Low-frequency (bass) signals can be directed to the subwoofer and/or the front left and right channels. This setting also determines the routing of LFE (low-frequency effect) signals found in Dolby Digital or DTS sources. Choices: SWFR (Subwoofer), FRONT

•Select SWFR if you connect a subwoofer. LFE and low-frequency signals from other channels are directed to the subwoofer.

•Select FRONT if you do not use a subwoofer. LFE and low-frequency signals from other channels are directed to the front left and right channels.

CROSS OVER (Crossover)

When BASS OUT is set to SWFR, you can use this feature to select a crossover (cutoff) frequency for all low- frequency signals. All frequencies below the selected frequency will be sent to the subwoofer position. Choices: 100Hz, 120Hz, 150Hz

LFE LEVEL (Low-frequency effect level)

Select to adjust the output level of the LFE (low-frequency effect) channel according to the capacity of your subwoofer. The LFE channel carries low-frequency special effects which are only added to certain scenes. This setting is effective only when this unit decodes Dolby Digital or DTS signals.

Choices: –20 to 0 dB

DISTANCE (Distance)

Select to adjust the distance of the subwoofer from the listening position.

Choices: 0.3 to 15.0 m (1.0 ft to 50.0 ft)

Initial setting: 3.0 m (10.0 ft)

■MUTE LEVEL (Muting level)

Use to adjust how much the mute function reduces the volume level.

Choices: MUTE, –20 dB

•Select MUTE to completely halt all sound output.

•Select –20 dB to reduce the current volume level by 20 dB.

C)MUTE LEVEL

pMUTE

-20dB

[p]/[p]:Select [ENTER]:Return