Adjusting the system parameters
3Press / so that “TURN ON VOLUME” is displayed in the front panel display.
ENTER
T U R N X O N X V O L U M E
4Press ENTER.
ENTER
Setting the DEMO MODE
You can test the sound beam output from this unit to experience the sound beam.
1Repeat steps 1 to 3 in “Using the system parameters” on page 71.
2Set the operation mode selector to YSP.
TV/AV
YSP
3Press / so that “DEMO MODE” is displayed in the front panel display.
ENTER
5 Press / to adjust the initial volume level.
ENTER
Control range: MAX, 99 to 01, OFF
Control step: 1
D E M O X M O D E
4 Press ENTER.
6Press STANDBY/ON on the remote control to set this unit to the standby mode.
STANDBY/ON
The new setting for the maximum volume level will be activated when you turn on the power of this unit next time.
ENTER