(See internal jumper options on page 18.)
Aux sends are Post-EQ, Post-fader
Aux sends are Post-insert, Post-EQ, Pre-fader
12aux send level 1–10
These knobs adjust the amount of signal sent to the corresponding AUX buses. Unity gain occurs at the zero setting, with 6dB additional gain is available above that.
13PRE (aux 7–8 and aux 9–10 ) - The default signal source for these AUX SENDS is post-fader.These switches are used for selecting the Pre-fader signals for Auxes 7-8 and 9-10.The normal Pre-fader signal is derived Post-EQ.
(See internal jumper options on page 18.)
When button is in the “OUT” position, aux sends are Post-EQ, Post-fader. When button is in the “IN” position, aux sends are Post-insert, Post-EQ, Pre-fader.
bus assignment features
The Input bus assignment section offers considerable flexibility for creating what eventually becomes the main output mix. Channels can be assigned to the indepen- dent Mono bus, the pan-paired Left/Right buses, or any of the pan-paired subgroups (1-2, 3-4, 5-6, 7-8). All assignments are derived post-fader, post-eq, and post-mute.
14pan control - The pan control positions the post-fader channel signal within the stereo left-right field, or between the Odd and Even groups of an assigned pair.The signal is down by approximately -3dB at the center-detent position when panning across the buses.
15bus assign
M (Mono)
Assigns the post-fader channel signal to the Mono Bus.The pan-pot position does not affect the signal to the Mono bus.
L-R (Left- Right)
Assigns the post-fader, pan-pot signals to the Left and Right Buses.
1-2 (Groups 1-2)
Assigns the post-fader, pan-pot signals to the Group 1 and Group 2 Buses.
3-4 (Groups 3-4)
Assigns the post-fader, pan-pot signals to the Group 3 and Group 4 Buses.
5-6 (Groups 5-6)
Assigns the post-fader, pan-pot signals to the Group 5 and Group 6 Buses.
7-8 (Groups 7-8)
Assigns the post-fader, pan-pot signals to the Group 7 and Group 8 Buses.
