Crest Audio HPW owner manual Matrix mix, Matrix output 1/4TRS jack

Page 39

matrix mix 0

matrix mix

The HPW features a 2-output Matrix section. Each Matrix can consist of a mixture of any of the 11 main mix buses: the 8 audio subgroups, Left, Right, and Mono. Each of these main buses feed the 2 matrix buses through individual Matrix Send pots, all located within the Master module, above the fader of the associated bus.These Sends were described in each of the previous sections describing the various buses.

Each Matrix mix can be used to create a unique combination of the various sub- mixes within the console. Pre- or Post-fader mixes are possible with the use of the PRE switches associated with the Matrix Send pots of each of the buses.The matrix outputs can be tailored to create the proper mix needed for each application.Typical uses are to create a vocal-rich feed for a video recording, a lower-level feed for the vestibule or waiting room, a room-independent mix for a performance video, etc.

68matrix output 1/4"TRS jack

The matrix output signal is available at this output jack.The jack is impedance-bal- anced, ground-compensated. The matrix ouputs can also be used as the source for the Alt outputs. This allows the dynamic range to be controlled and room ambi- enced to be added to the matrix signal.

Tip is +Drive, Ring is -Drive Return, Sleeve is Chassis Ground Send (Drive) impedance is 50Ω

Ring impedance is 50Ω to Audio Ground Nominal Operating Level= +4dBu

Max Output Level= +21dBu (into 2kΩ or higher)

68

p. 39

Image 39

Contents Hpwtm Mixing Console Page HPW Page Sound Level dBA, Slow Response Important Safety InstructionsBewahren SIE Diese Sicherheitshinweise AUF Gardez CES Instructions Guarde Estas Instrucciones Page Table of contents Mute Block diagramMono Output +48VTALKBACK If the channel peak LED is Mono inputAux send features EQ featuresLeft- Right Bus assignment featuresAux send level Bus assign MonoChannel muting features Channel monitoring featuresChannel fader Mono input options HPW InputHPW Input EQ PCB lower Direct out D.O. option HPW Mono InputUser options Aux PRE optionRear panel features 4features overviewAutomix Automix optionalStereo input options Both in the OUT position true stereo signal passes throughStereo inputs Affected by the Mute switchBus Assign Signal monitoring featuresHPW Input EQ PCB upper 5stereo input optionsSB7 HPW Stereo InputRear panel connectors 6groups audio subgroups FeaturesGroups Group monitoring featuresFader reverse w/LED Using the HPW as a monitor console6groups Fader-reverse functionCreating additional mixes Group mixing featuresGroup connectors- rear panel Group output 1/4TRS jackInsert jack 1/4TRS jack 51 AFL AuxesAuxes auxiliary mixes 50 PK/Sig LEDInsert jack 1/4TRS jack Aux connectors-rear panel7auxes Aux output 1/4TRS and male XLR jacks57 PK/Sig LED FeaturesLeft right Left and right main audio busesUse the Fader 8left right64 PK/Sig LED Mono outputMono main audio bus 63 100mm FaderMono connectors- rear panel Left right, mono outputMain Mono output male XLR jack Matrix mix Matrix mixMatrix output 1/4TRS jack Stereo lo-cut filter Lo cut switch¡master section GainMaster section ¡ Aux 1/2 or 9/10 selector buttonAux sends 1-2 or Groups Master sectionStereo fader Bus Assign Mono78 PK/Sig LED Alternate outputs features Compressor MasterGain reduction metering LimiterBalance Ambience inputs featuresHigh frequency- HF Low frequency- LFMute level 99 PRELevel MuteMaster section monitoring and control ¡ master sectionMonitor metering Source select switchesSolo metering Selected to avoid errorsMonitor output 1/4TRS jack rear panel Solo operationHeadphone source Mute scene edit/cancelSingle scene mode PresetsPower supply monitor Lamp connectorsTalkback input Internal supply Power supply internalOn-off switch Ext DC ConnectorExternal power supply front External power supply rear Power supplyDC output Power supply controls frontPower supply controls rear AC input DC statusPower supply dual hookup External Power SupplyPowering the HPW Power supply dual+/- 18 volts @ 3 amps Main analog rails £ specifications