maintenance (Mixer)
Suspension
The rigid type axle and associated hardware (Figure 38) should be periodically inspected for signs of excessive wear, elongation of bolt holes, and loosening of fasteners. Replace all damaged parts immediately.
OFF ON
SINGLE
PHASE
115/230 VAC 2.0 HP ELECTRIC
MOTOR
115 230
CHECK FOR TIGHTNESS
Figure 39. No Spraying of Water
WARNING
When rotating the mixing drum from the dump position to the upright position, keep hands clear of safety grate. The possibility exists of hands or fingers being crushed (Figure 40).
RIGID TYPE
AXLE
Figure 38. Axle Support Components
Mixer Cleaning
1.ALWAYS disconnect the spark plug wire (gasoline engines) before cleaning the inside of the drum. If mixer is equipped with an electric motor remove power cord from AC power receptacle. In addition make sure the clutch engagement lever is
2.Make sure the rear section of the safety grate is connected to the mixing drum.
3.At the end of each day’s operation, place mixer drum in an upright position and spray inside of tub immediately with water to prevent lumps of dried mortar or plaster from forming and contamination of future batches, DO NOT allow a buildup of materials to form on the blades or anywhere inside the drum.
4.Rotate mixer to dump position and remove debris.
5.Thoroughly clean the entire mixer, wheels, cabinet and frame.
6.NEVER pour or spray water over the engine or electric motor (Figure 39).
CRUSH HAZARD AREA. KEEP HANDS AND FINGERS CLEAR OF SAFETY 
GRATE AT ALL TIMES.
Figure 40. Safety Grate (Crush Hazard)
7.When cleaning of the entire mixer is done, return mixing drum to an upright position.
page 32 —