8.MAIN LEFT/RIGHT OUTPUTS:
1/4" TS and a fully balanced XLR output of the Left and Right mixes. The output level is set by the Master Left and Right Faders (35). Both outputs can be used simultaneously.
9.MAIN MONO OUTPUTS:
1/4" TS and a fully balanced XLR output of the mono mix (left/right summed). The output level is set by the Master Mono Fader (36).
MASTER SECTION
The Master Section contains all the master level controls, effects send/return controls, headphone and tape controls as well as the level meters. It is important that this area of the board be set up properly in order to get the most from the Input Channel Section of your RQ.
Warning: Keep all faders at the lowest position until you are ready to set your final levels. Having the master faders in any other position while setting up the Input Channel Section could result in accidental signal overload and/or sudden burst of signal at high levels.
10
14
15
11 
16
12 | 17 |
18 
13
10.TAPE INPUT/OUTPUT:
The Tape Input jacks are set up for a
11.TAPE TO MONITOR 1 LEVEL: Adjusts the level of the Tape Input signal (10) supplied to the Monitor 1 mix. This control is independent of the Tape L/R Level.
12.TAPE TO MONITOR 2 LEVEL:
Adjusts the level of the Tape Input signal (10) supplied to the Monitor 2 mix. This control is independent of the tape L/R level.
13.TAPE TO L/R LEVEL:
Adjusts the level of the Tape Input signal (10) supplied to the L/R mix.
14.PHANTOM POWER SWITCH:
Applies 48VDC voltage to the input XLR connectors to power microphones that require it. If
phantom power is used, do not connect unbalanced dynamic microphones or other devices to the XLR inputs that cannot handle this voltage. (Some wireless receivers may be damaged. Consult their manuals.) The line input jacks (38) are not connected to the 48V supply and are safe for all inputs (balanced or unbalanced).
15.PHANTOM POWER LED:
This LED illuminates to indicate that phantom power has been switched on by the Phantom Power Switch (14).
5