DOD Bass30 manual

Page 11

1. Connect your instrument to the Bass30 input jack.

2a.(mono) Connect the left output to the input of your amplifier, or line input of a mixing console.

2b. (stereo) Connect the left and right outputs to the inputs of two amplifiers, or two line inputs of a mixing console.

2c. (bi-amp)Connect the left output to the power amp driving the low frequency speakers, and the right output to the power amp driving the high frequency speakers.

3.Set the tone controls of the amplifier(s) or mixing console to the flat position. If you are running stereo into a mixer set the pan controls hard left and hard right. Turn your amplifier or mixer’s volume level down.

4.Apply power to the Bass30 by connecting the PS750 from the power jack to an AC outlet.

5.Turn the power switch of your amplifier(s) or mixer to the “on” position.

6.Begin playing and gradually increase the amplifier(s) or mixer’s volume until the desired level is achieved.

7

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Page Electromagnetic Compatibility Declaration of Conformity Table of Contents Introduction Guided Tour of the Bass30 Front Panel Section ONE OverviewPage Page Input Jack Connect your instrument to this jack Rear PanelMaking Connections Getting StartedPage Section TWO About the Bass30 Performance ModeSelecting a Preset Footswitches Accessing the Tuner Jam-A-Longª User Interface Section Three Edit ModeEditing a Preset Page Page Expression Pedal Assignments Page Storing/Copying a Preset Section Four Effects Definitions Page Page Page Page Parameter Definitions Page Page Section Five Tutorial Creating a PresetPage Page Congratulations! You have successfully created a new Preset Section SIX Other Stuff Resetting the Bass30Calibrating the Expression Pedal Maintenance and ServiceSection Seven Appendix WarrantyPower Consumption 5.5 watts Specifications
Top Page Image Contents