DOD Bass30 manual Getting Started, Making Connections

Page 10

Getting Started

The Bass30 is ready for you to plug in and play. It already has a variety of sounds programmed into both the 30 factory and 30 user Presets. You will find that the User Presets are exact duplicates of the Factory Presets. The Factory Presets are permanently written into the Bass30 and cannot be changed. The User Presets can be overwritten with your sound creations as many times as you choose.

Making Connections

The Bass30 can be run in mono, stereo, or bi-amp configurations. The following connections outline the set up for all three applications. These steps should be performed in the order that are listed here. Make sure that you do not connect the power to the Bass30, or turn on the power to your amplifier until the completion of these steps.

6

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Page Electromagnetic Compatibility Declaration of Conformity Table of Contents Introduction Section ONE Overview Guided Tour of the Bass30 Front PanelPage Page Rear Panel Input Jack Connect your instrument to this jackGetting Started Making ConnectionsPage Selecting a Preset Performance ModeSection TWO About the Bass30 Footswitches Accessing the Tuner Jam-A-Longª Editing a Preset Section Three Edit ModeUser Interface Page Page Expression Pedal Assignments Page Storing/Copying a Preset Section Four Effects Definitions Page Page Page Page Parameter Definitions Page Page Creating a Preset Section Five TutorialPage Page Congratulations! You have successfully created a new Preset Resetting the Bass30 Section SIX Other StuffMaintenance and Service Calibrating the Expression PedalWarranty Section Seven AppendixSpecifications Power Consumption 5.5 watts
Top Page Image Contents