DOD Bass30 manual

Page 17

1.Comp/Wah - This button will access the Compressor/Limiter and Wah effects. Successive presses of this button will toggle between the Compressor/Limiter and the Wah. The selected effect is indicated by the flashing LED. The status of the selected effect can then be changed by rotating the Data Wheel. The Compressor contains 4 parameters available for adjustment. These parameters will light when the Compressor has been selected and may be accessed by using the Parameters button. Compression and Wah can be used simultaneously. See page 18 for a complete description of Compression and Wah effects.

2.Expression - This button is used to assign functions to the Expression Pedal. Pressing this button once will cause the Expression LED and the LED of the Parameter currently assigned to the Expression pedal to begin flashing. Rotating the Data Wheel will change the Expression Pedal’s Parameter assignment. The new Parameter selection will be indicated by a flashing LED in one of the effects groups, or parameter section. Only one Parameter at a time can be controlled by the Expression Pedal. Successive presses of this button will allow you to edit the range of the Expression Pedal. See page 15 for more information on assigning the Expression Pedal.

3.Model - This button will access the Amp and Guitar Modeling section. The LED next to the currently selected Amp/Guitar Model will flash. Successive presses of the Model button will advance through all available Amp and Guitar Models. Only one Model can be used in each Preset. The Display will show the status of the Modeling section as either on, or two dashes --indicating bypass. Rotate the Data Wheel to change the status. See page 18 for a complete description of Amp/Guitar Models.

4.Tone/Gate - This button will access the Gain, and EQ of the selected Model, as well as Volume and Noise Gate. The selected Modeling Parameter will be indicated by a flashing LED. The Display will show the value of the selected Parameter. Rotating the Data Wheel will adjust the value. Successive presses of the Tone/Gate button will advance through these Parameters. A separate value for each Modeling Parameter can be stored to Presets. See the Modeling section on page 18 for a complete description of Tone adjustments and page 20 for the Noise Gate.

13

Image 17 DOD Bass30 manual
Contents Page Electromagnetic Compatibility Declaration of Conformity Table of Contents Introduction Guided Tour of the Bass30 Front Panel Section ONE OverviewPage Page Input Jack Connect your instrument to this jack Rear PanelMaking Connections Getting StartedPage Section TWO About the Bass30 Performance ModeSelecting a Preset Footswitches Accessing the Tuner Jam-A-Longª User Interface Section Three Edit ModeEditing a Preset Page Page Expression Pedal Assignments Page Storing/Copying a Preset Section Four Effects Definitions Page Page Page Page Parameter Definitions Page Page Section Five Tutorial Creating a PresetPage Page Congratulations! You have successfully created a new Preset Section SIX Other Stuff Resetting the Bass30Calibrating the Expression Pedal Maintenance and ServiceSection Seven Appendix WarrantyPower Consumption 5.5 watts Specifications