→Set the counter display to “FreeTime” and check the
amount of recordable time. (→ p.56)
Is the bounce setting (“BOUNCE”) appropriate? (→ p.29)
→If the bounce setting (“BOUNCE”) is set to “CONV,”
the recording will be created as a new song. (→ p.51)
Can’t record two tracks simultaneously
The “EFFECT ASSIGN” (effect insert location) may have been set to “GUITAR.”
→If this is set to “GUITAR,” only one track can be recorded simultaneously.
Input sound or recorded sound contains noise or distor- tion
Is the [TRIM] knob raised to an appropriate level?
→If the [TRIM] setting is too high the sound will distort;
if it is too low, noise will be heard. (→ p.18)
If the effect input is distorted, make the following adjustments.
Guitar/insert effect: Hold down the [SHIFT] key and press the [DISPLAY] key, and select the “PRE” setting for “DISPLAY.” Then use [TRIM] etc. to adjust the input volume as high as possible without allowing “CLIP” to light in the level meter.
Master effect: Adjust the faders and send level so that “CLIP” for the master L/R track does not light.
Final effect: Adjust the faders so that “CLIP” does not light for the master L/R track.
If the effect output is distorted, make the following adjustments.
Guitar/insert effect: Adjust the effect parameters and [TRIM] while listening to the sound.
Appendices
Master/final effect: Adjust the effect parameters so that “CLIP” for the master L/R track does not light.
Effect does not apply
Tuner mode may have been selected.
→The effect will be bypassed (off) when the tuner is selected.
Is the master volume of the effect program set to “0” or close to “0”?
→Press the [EFFECT] key, then press the [CURSOR] right key several times to display “ProgMVol,” and raise the volume setting.
Is the [TRIM] knob raised to an appropriate level?
→If the [TRIM] setting is too low, the effect may not be applied in some cases.
Guitar/insert effect does not apply
Is the effect insert location appropriate?
→Hold down the [SHIFT] key and press the [EFFECT]
key, and set “EFFECT ASSIGN” to “GUITAR” or “INSERT.” (→ p.35)
It is not possible to use a guitar/insert effect on a play- back track.
Master effect does not apply
Is the effect insert location correct?
→Hold down the [SHIFT] key and press the [EFFECT] key, and set “EFFECT ASSIGN” to “MASTER.”
(→ p.35)
Is the send level from each track set to “0”or close to “0”?
→Press the [MIXER] key, and use the [CURSOR] keys to
raise the | 85 |