AT&T 8410 specification

[dial tone]

3If you are using an 8410 with a display, press [ Menu ] and then press the softkey below Prog

If your 8410 does not have a display or if Prog is not available on your display, press [ Program ]

or Dial AD Program access code

4 Press [ AD xxxxx ] to be programmed			[dial tone]

5Dial outside number, extension, or feature access code you want to store (up to 24 digits)

Note: If your 8410 has a display, you may be able to use the softkeys to add special functions such as Pause, Mark, or Wait into the telephone numbers programmed on the AD button.

If you are programming an outside number, be sure to include a trunk code, if applicable.

6 Press [ # ]			[confirmation tone]

●Number is stored

●Repeat Steps 4 through 6 to program additional buttons

7Hang up or press [ Drop ] to end programming

To place an AD call	1	Press selected [	AD xxxxx	]	[ringback tone]
	2	Call is automatically dialed

To program/reprogram an outside number, extension, or feature access code into a personal list

1On a separate sheet of paper, write down the outside numbers, extensions, and/or feature access codes you want to program as items on your personal lists(s)

Note: Each phone number or feature access code is stored as a separate item.

2 Pick up handset

[dial tone]

Note: If you are using the built-in speakerphone, you must either press a call appearance button or press [ Speaker ] before you begin Step 3.

3If you are using an 8410 with a display, press [ Menu ] and then press the softkey below Prog

If your 8410 does not have a display or if Prog is not available on your display, press [ Program ]

or Dial AD Program access code

[dial tone]

4 Dial Personal List number (1, 2, or 3)

[dial tone]