Speakerphone

Note: If you are uncertain whether your voice terminal is set for the Speaker (listen-only) feature or the Speakerphone (listen and talk) feature, check with your system manager.

Use the following procedures if your voice terminal is set for the Speakerphone (speak and listen) feature.

For directions on using the Reset Speakerphone feature, see "Reset Speakerphone" in this section.

To place/answer a call without lifting the handset, or to use speakerphone with any feature

1Press [ Speaker ]

●Red light next to [ Speaker ] goes on steadily

2Place or answer call, or access selected feature

3Adjust speakerphone volume if necessary

●To raise the volume, press the right half of the Volume control button labeled [ ∧ ] ;

to lower the volume, press the left half of the Volume control button labeled [ ∨ ]

●If you have a display, it shows

SPEAKER L>>>>>	H

(There are eight possible volume settings. On the display, one arrow is the lowest setting, and eight arrows is the highest setting)

Note: The Volume control does not affect an external speakerphone attached to your voice terminal.

To prevent the other	Note: If the Speakerphone feature is not active, the
party from hearing you	Mute feature turns off the microphone associated with
	the handset (not the speakerphone). However, if the
	speakerphone is active and the handset is not active,
	then the Mute feature turns off the microphone
	associated with the speakerphone (not the handset).
	1 Press [ Mute ]
	● Red light goes on and other party cannot hear
	you
	2 Press [ Mute ] again to resume talking to party
	● Red light goes off and other party can hear you
	again