JVC HR-E939EG Enter Showview Number, Close Menu, When Using a Satellite Tuner, Preparation

	ENTER SHOWVIEW
	NUMBER
	Press OK, and a cursor
	appears above “GUIDE	12345 5
4 PROG”. Then, using the
		GUIDE PROG TV PROG
	NUMBER keys, input the
	ShowView number (found	1	1
	in most TV listings) of a
	program scheduled to be	[0 – 9] =
	broadcast on each station
	on the list from step 1,	When entering a ShowView
	starting at the top. If you	number for ARD
	enter the wrong number,
	press CANCEL and input the correct number.
	ENTER CHANNEL POSITION
	NUMBER
4	Press OK and the display
	under “TV PROG” begins
	5 blinking.	GUIDE PROG TV PROG
		250	39

If the blinking number under “TV PROG” agrees with the channel

position . . .[5°] =

. . . press OK.

If the numbers do not agree . . .

. . . input the channel position using PUSH JOG%Þ or the NUMBER keys, then press OK.

●If you input the ShowView number of a program that has already aired, “ERROR” appears on screen for a few seconds. Input the correct ShowView number.

●Repeat steps 4 and 5 as necessary.

CLOSE MENU

6 Press CH SET and selection is complete.

If you already know the Guide Prog. number for a station . . .

1– After step 3, press PUSH JOG %.

●The GUIDE PROG number begins blinking.

2– Enter the Guide Prog. number using the NUMBER keys or PUSH JOG%Þ, then press PUSH JOG %.

●The TV PROG number begins blinking.

3– Enter the channel position using the NUMBER keys or PUSH JOG%Þ, then press PUSH JOG% .

●Repeat 2 and 3 as necessary. 4– Press CH SET.

EN23

When Using A Satellite

Tuner

Satellite Antenna		Aerial or Cable
Ex. 1	Ex. 2
Satellite	Satellite
	Tuner and
Tuner
	Decoder
AV2 IN/DECODER

AV2 SELECT Switch

TV Receiver

Preparation

1– Connect the satellite tuner to the AV2 IN/DECODER connector on the rear of your recorder.

2– Set the AV2 SELECT switch to "AV2".

To Record Satellite Broadcasts . . .

1– Select the appropriate channel on the satellite tuner.

2– Press NUMBER key "0" to set your recorder's input mode to "AUX2".

3– Start recording (☞ pg. 16, steps 3 – 6).

To Record Satellite Broadcasts Using ShowView Timer Recording . . .

1– Perform Guide Prog. Number setting.

●In step 5 in the left column, press NUMBER key "0" to set "TV PROG" to "AUX2".

2– Perform ShowView Timer Recording (☞ pg. 24).

To Record Satellite Broadcasts Using Regular Timer Recording . . .

1– In step 6 on page 26, press TV PROG. +/– to set the channel position to "AUX2".

NOTES:

●When timer-recording a satellite programme, first set the satellite tuner to the appropriate channel before the selected programme begins and then set the satellite tuner's timer. If your satellite tuner does not have a timer, leave it switched on.

●If your recorder's front panel VIDEO and/or AUDIO connec- tors are being used, they take priority and "AUX2" cannot be selected. Make sure no cables are connected to the front panel connectors when performing this procedure.